Looking very good. 👍🏻I think you have the elevator servo other way around. The spline should be closer to the horn on the elevator not away. That’s why the rod was short.
Did you by any chance weigh the aircraft without any electronics (without motor, battery, esc, servos etc.)? And whats the flight ready weight of your setup? Greetings from Germany!
Looking very good. 👍🏻I think you have the elevator servo other way around. The spline should be closer to the horn on the elevator not away. That’s why the rod was short.
I considered turning the servo around, but the wire would be pointing toward the rudder. It made the servo wire turn too tight for my liking.
Great videos what type of epoxy do you use for the hinges
I use BSI 30 min epoxy. Any two part epoxy should work well. The 30 min gives you enough time to get everything in place before it starts setting up.
Partie 3
Did you by any chance weigh the aircraft without any electronics (without motor, battery, esc, servos etc.)? And whats the flight ready weight of your setup? Greetings from Germany!
Hello Germany. I did not get a weight of just the airframe. My take off weight is around 9lbs 5oz (4.224 kg).