【Feel good】A Japanese woodworker assembles a task with a time limit of 3 hours and 30 minutes
Вставка
- Опубліковано 2 січ 2023
- This time, I took a picture of the assembly work of the [National Qualification] 2nd grade carpenter skill assignment (trial assignment) that was changed in 2024.
This task is characterized by a high degree of freedom during assembly, with a large number of nail-fixing tasks.
In order to match the core of the material, it may sometimes be necessary to make adjustments such as reprocessing the body.
I didn't come up with a special method for this task either, but please try to come up with a strategy while practicing.
Let's do our best to pass!
All I have asked Santa this year was English subtitles on your videos. In the hindsight I should have asked for subs on ALL videos, esp. on sumituke and whiteboard drawings explanations.
I am glad that you are interested.
筋交と振れ垂木を先に組む方法はあまり良くないですか?
考えては見たんですが練習材が少なかったので試せませんでした。
一度試してみてください!
木削りを早くするポイントっありますか?あと小口鉋かける時濡れたウエスで拭いていますがなぜでしょうか?
木造りを早く行うポイントですか
難しい質問ですね
僕自体結構時間かかってますから(笑)
目指す方向で早く行う方法が変わります
完璧な形を目指す場合の早く行うコツは、鉋をしっかり調整して思い通りに削り、無駄に削らないようにすることです。
シンプルに時間短縮を考えるなら、そもそも少し大きめに仕上げる事ですね。
削る量が減れば早く終わります。
木口を濡らすのはやってみればわかると思いますよ!
ぜひ試してみてください
@@daiku-manual ありがとうございます
釘打つ所に使うキリは何ミリのを使用していますか?
3mmの三角下穴キリです
釘の穴を空ける時のドリルのビットは何mmですか??
三角下穴キリの4mmあたりがいいと思います
深さで太さを調整してください
何度やっても筋交いの交差する部分の勾配が合わないのか振れ垂木にしっかりくっつかず隙間があいたり片方だけくっついたり、例えば、✕がXみたいに細長く?なってしまって上手くいきません、墨付けをしている製図自体は正しいはずなのですが…
概要欄のLINEの方にご連絡いただければ参考図を送りますよ
本番の試験では組み立てる前に仕上げ鉋で仕上げてから組み立てですか?
この課題は墨付け前に仕上げて、墨は残して組み立てますよ。
その上で糸面と木口仕上げを行います。