Rp1000 The correct Wha and Volume calibration procedure

Come effettuare la giusta calibrazione del pedale del volume e del Wah Wah
Expression Pedal Calibration
The Expression Pedal on the RP1000 needs to be recalibrated for use after you do a factory reset. This calibration procedure automatically starts after the factory reset procedure is completed. (You can also start the calibration procedure by pressing and holding the currently active preset’s footswitch for about 5 seconds.) If the pedal’s calibration fails, or if the pedal does not function properly, it can be re-calibrated using the calibration procedure. This will not erase the User presets. The procedure for calibrating the expression pedal is as follows:
1. Press and hold the currently active preset’s footswitch until PEDL CAL appears in the display
(BYPASS, TUNER, and EXIT will be displayed before PEDL CAL is accessed, after about 5 seconds.)
2. When the Display prompts you with TOE DowN, rock the Expression Pedal forward (toe down) and
press Footswitch 5.
3. When the Display prompts you with TOE UP, rock the Expression Pedal back (toe up) and press
Footswitch 5.
4. The Display now prompts you to calibrate the V-Switch sensitivity (VSWitchxxx), where XXX is the
current V-Switch threshold. Rock the Expression Pedal forward and press firmly on the toe once to
turn the V-Switch on (WAH ON), and again to turn the V-Switch off (WAH OFF).
5. If the V-Switch is too sensitive, press the Up Footswitch to raise the threshold (range is 0-199). The
Down Footswitch decreases sensitivity. Keep testing the V-Switch sensitivity and adjust the threshold until it only engages when you want it to (too sensitive a setting will lead to the V-Switch falsely triggering on or off when using the Expression Pedal).
6. When the V-Switch sensitivity is set to your satisfaction, press Footswitch 5 to exit.