Розмір відео: 1280 X 720853 X 480640 X 360
Показувати елементи керування програвачем
Автоматичне відтворення
Автоповтор
sounds a tad lean try going up one or two sizes on the main
That looked like a great fishing spot you passed. Is there good fishing up there?
Great fishing actually I have 2 bass mounted over the past 3 years
@@2strokeboys191 All the ponds that had fish in them back in the day have like none, or barely any now. Someone should invent a fersh water coral system, and a means to put it into the ponds, making them deeper.
My cr85r done the same thing
The idle is too high, your engine braking too much, too high of a gear while not going fat enough.
Later found the bike was running lean. Adjusted the carb needle and it was good to go
2stroke boys nice I have an 06 cr85r bored to a 110 she Lifts up in 6th gear no problem
@@ACP336 i have a cr 85r bigwheel as well and could you give me a link to the website you got the big bore kit off or where did you get it done. ??
@@paulmurphy2503 I just got the 110cc piston for it then sent out the piston and cylinder to get them matched and replated
sounds a tad lean try going up one or two sizes on the main
That looked like a great fishing spot you passed. Is there good fishing up there?
Great fishing actually I have 2 bass mounted over the past 3 years
@@2strokeboys191 All the ponds that had fish in them back in the day have like none, or barely any now. Someone should invent a fersh water coral system, and a means to put it into the ponds, making them deeper.
My cr85r done the same thing
The idle is too high, your engine braking too much, too high of a gear while not going fat enough.
Later found the bike was running lean. Adjusted the carb needle and it was good to go
2stroke boys nice I have an 06 cr85r bored to a 110 she Lifts up in 6th gear no problem
@@ACP336 i have a cr 85r bigwheel as well and could you give me a link to the website you got the big bore kit off or where did you get it done. ??
@@paulmurphy2503 I just got the 110cc piston for it then sent out the piston and cylinder to get them matched and replated