if too much so far im doing this for more than 10 yrs no complain at all.Is how you put the amount of oil or grease.try to think two metal rubbing each other with no lubrication what will happen? thanks
@Roddreel very interesting are you a chemist or engineer. Not everyone can mix their own greases.. very impressive! BTW. What is that little bearing spinnng tool you use. ?
@@Roddreel Are you talking about those two little dimples cast in the rotor and what would you line up to them? reason am asking i took mine off and didnt notice or mark the nut so wondering how to position it. the cover for the nut is toothed so to an extent that also determines where the nut lays for the cover to line up with the three screw holes. Also i notice when you were putting the side plates on you didnt tighten down and you attached handle then tightened. you were checking for binding ?
Why do you speed it up???????
Definitely something I can't do 😂😂😂.
Just practice sir
what size screw driver is used for the screw behind the rubber plug to take the rear chrome guard off ?
im not familiar with sizes but the smallest from craftsman as long as its long 3mm head
just noticed you greased the anti reverse bearing (ARB) collar, that is a no no. no grease should be on the ARB it could cause the ARB to slip.
if too much so far im doing this for more than 10 yrs no complain at all.Is how you put the amount of oil or grease.try to think two metal rubbing each other with no lubrication what will happen? thanks
Nope it doesn't,I also put grease on the ARB and also no complaints
What are you using on those gears.. should be Shimano DG13 (SRG) gear grease.
No I don’t use shimano grease anymore I use my own grease full synthetic but different viscosity
ua-cam.com/video/XtZPZBPnpAE/v-deo.htmlsi=MUDj39ygkvg5TFy2
@Roddreel very interesting are you a chemist or engineer. Not everyone can mix their own greases.. very impressive! BTW. What is that little bearing spinnng tool you use. ?
@@ShorrockPaul custom made bearing checker
What is the type of the screw which opens the small round screw on the line roler?And which screw for rotor nut please?
.8 hex screw tool
@@Roddreel and for rotor nut please?
How do you determine how tight to tighten the main rotor nut ?
there are 2 marks near the rotor.not too loose and not too tight.
@@Roddreel Are you talking about those two little dimples cast in the rotor and what would you line up to them? reason am asking i took mine off and didnt notice or mark the nut so wondering how to position it. the cover for the nut is toothed so to an extent that also determines where the nut lays for the cover to line up with the three screw holes.
Also i notice when you were putting the side plates on you didnt tighten down and you attached handle then tightened. you were checking for binding ?
What is the grease you are using?. And oil?.
synthetic sir
Have you ever done any shimming on these reels ?
No sir
To me, the 2019 Stella is a product that cuts corners. It has lost the value of the previous Stella.
😂😂😂 hancurlah reel servis kasar banget motor kalee di servis
Why do you say that ?