GOODMAN GAS FURNACE STOPPING THEN RESTARTING MID CYCLE
Вставка
- Опубліковано 8 вер 2024
- GOODMAN GAS FURNACE STOPPING THEN RESTARTING MID CYCLE
merch = teespring.com/...
/ stevenlavimoniere
lavimoniere productions llc
subscribe to my channel
/ @stevenlavimoniere
lavimoniereplum...
Been putting in Goodmans for over 9 years, anytime you see rust on vent piping usually indicates of a block or partially block base chimney, possible intimating on pressure switch due to lack of venting.
You can't stop a Goodman! You're the man Steve!
What no $100 bill to clean your sensors like Ted Cook? Haha
Pull the hoses on the inducer, check for build up, also do a pressure test on the inducer fan assembly, could be barely hanging in there!
Thanks again for the videos!😎👍🏻🇺🇲🍺🥃🥃
Hard to stop a goodman!! Thanks Steve for another great vid:)
Hopefully a little dirt on the flame sensor was all it was. Please let us know if you have to revisit it.
I don't like the look of that vent connector. Is that an unlined chimney?
Good ol Goodman
You may want to check the chimney cap if it has one or not and if not suggest getting one in place, to save the water from rotting out flue. IMO
Nothing quite like a beautifully placed condensate trap to really tie it all together
That's my furnace Steve ... 9 year old and runs like a top ... but I clean FS and burners yearly, new filter every 2 months .... I installed it in a 100 year old house, but ran a chimney liner and cap ... when walking my dog I always watch the chimney output (vapor) to make sure it's running at full output
Thank Goodness for Goodman
Short cycling and condensing ,Unlined chimney? Sometimes it's a wrongly adjusted anticipator setting in a mechanical thermostat and or a defective pressure switch ,dirty sensor ,plugged air filter, plugged "A" coil, Dirty blower fan wheel .
Static pressure? Temp rise. Would of checked the board to see if it was failing. Thanks for the vids
Hey Steve, Let's see more footage of your car collection.
Great job Steve
Nice place to run the plumbing
Tough one to troubleshoot. Let it ride then dig deeper if need be.
Great Video. Thank you for sharing
Those flame sensor are 90 percent of the time the issue on this particular unit. I take a fine sand paper and good as new
Nice work
Another kick ass video Steve 💥👌👍☝️
You have been working on a lot of Goodman's lately.
Hello Steve!
I wonder what code was flashing?
Hey Steve and Miss Molly! Workin’ again y’all. 👍👍. Can’t stop a Goodman mama!
What's up Steve?!
Bad limit switch?
Sure don't design things with the service guy in mind. :(
Damned straight! It seems like they would rather sell new units instead. It is the new, "woke" financial strategy.
👍
Steve to Control..........We have Ignition. Molly and I will be back home in 2024....
I hope I got enough dog food for the trip......
Steven, when you come back to the truck is Miss Molly sleeping in her bed or is she patiently waiting for you 🤔
Sometimes he shows her from inside the house and shes on the window sill looking out for him. Lol. Im sure she rests sometimes too
Howdy Steve and Molly
Ol crusty
Thank God we’re getting rid of LnG 😂
First 🥇
I was driving earlier lol
@@markpowell1031 😆
Hello Steve!
Frank Rizzo the former Mayor of Philadelphia
Died the year I was born, 91