Відео

What is the min spec on these rotors for m sport 370/30?

Bump for the t 20 torx screws and clips that hold the filter door in.

Bro! This video was extremely helpful and the question I had where already answered through the comments. Much appreciated!

Thank you for posting. Pretty informative. Ive been thinking about doing this to my 435i. Just the stock charge pipe makes me nervous on my untuned N55 lol.

Never run the cable over airbag. It is serious safety hazard. People please don’t follow.

Bro thank you! 🎉

torque specs?

370mm ??

I just bought bad wheels. Original components, with rivets. Metal disk, aluminum hub. Purchased ones can easily warp

Ive got a 335d MSport xdrive with the blue calipers. Im getting lots of brake squeal at very low speeds. Any suggestions what is causing this and how to fix it?

Did you bleed the brakes at all?

When u clean caliper I’d make sure to use wire brush right where the pads slide. I even used a cotton swab with break clean on it to make sure it was smooth and clean

I need to look at my brakes on my F31 335d as I have a slight brake judder.....I measured the front disc run out and only had 0.02mm on both discs.....so must check the rear as 0.02mm is not much!!

What a shame my F80 brakes were much better than the G82. BMW is an awkward company with the tendency to go backwards sometimes.

What does turn off ignition mean ?

Thanks for sharing!

Is it the same process for front and rear pad change?

Great video bro. Switching from Infiniti Q50 to M4 and I’m used to doing the maintenance on my Q and this is straight forward. Similar to the process on the Q

how do you get the car on jackstands in that way? is there a spot close to the jack point?

Used Maxlife Atf for years with no tranny problems . It is 24 dollars a gallon at Wahlmart !

Thanks brah

Thank you.

Thanks for the instructions, just changed mine!

Always open your fill plug first before u drain

What’s the part number for the brake wear sensor?

Thanks for the video - one note - You used the E16 star socket but my 2016 435i ZHP with Brembo msport used a standard 18mm socket sadly i went and bought a set of of the E Star sockets before I knew . Odd that they are different ( I’ll probably return) Again thanks for the video- helped me get through my pads and two piece rotor install -

just quick question, how much mm spacer did you put on?😅

Great

What an extensive procedure! Remember how quickly it's done with an E46-type.

The brake wear sensor is only on the driver's side, not on both sides?

So it is similar to my 2012 X3; good to know. thank you!

Awesome now i know something new 🫡🙏🏾💪🏾🫱🏽‍🫲🏿

I would help to mentioned what size the (2) Torx "screws" are. Also the (2) clips that need to be released. It's a tutorial after all.

ALWAYS REMOVE THE FASTENERS ON THE FLUID FILLER END FIRST, JUST IN CASE FASTENER IS SEIZED.

Absolutely great video. Thanks a lot!

Quick question 🙋 can u put link down for rear pad too ? Also rotors gonna fit either u put in front or rear right !!!

Ive always just put a large sheet of cardboard down and then just slide around on my back on that.

I want too try hot shots secrets blue diamond dexron VI mercon LV transmission fluid for a bmw 320d 2012 F31 engine. Will it work

Maybe invest in a Unilite torch

Great vid - I'm thinking of doing this on my F32 MSport. A few of questions. 1. Please can you clarify the socket size, there were two sizes mentioned here. Also please repeat the torque measurement. 2. What lubricant did you use for the pad - Does it need a specific product ? 3. A general question for all viewers - Which rotors do you recommend (UK market) ? There has to be a good middle option between the dearest and cheapest. Thanks in advance.

Can you get this done n f30 3 series

Y’all think this applies to the 2020 g20 chassis?😅 trying to do my m340

Nice video. Thanks! How much psi of boost you run at peak? Just went FBO on my F36 2015 435i gran coupe Xdrive. Curious what to expect.

Are you "assuming" they'll send you a new filter under warranty based on their "lifetime warranty on everything we sell" statement, or is that what they told you directly? A filter doing it's job, over its projected lifespan is not a defective part. As such, I highly doubt it would qualify for warranty replacement?

Thanks for the video!

How did you level the car? I didn't realize it should be well leveled...

No tienes fotos de esa parte tengo el mismo carro y se me cortaron los cables del fender y el bumper quiero ver si me faltan sensores , me marca el senslr de speed

I have the same fender all wires cut, lights and sensors and horn but are not wich is for each one can you help me is the same car

Way to destroy the paint on your calipers bruh.

What all upgrades do you have just intercooler upgrade ???