TESimpleSavings
TESimpleSavings
  • 8
  • 309 842
2013 Honor Flight 9 21
On September, 21, 2013, Kentucky's Touchstone Energy Cooperatives sponsored a Bluegrass Chapter Honor Flight. Twenty five heroes were on board.
Переглядів: 123

Відео

VTS 01 1
Переглядів 1711 років тому
VTS 01 1
VTS 01 0
Переглядів 1511 років тому
VTS 01 0
TWE for WKYT MASTER.wmv
Переглядів 13414 років тому
Together We Save WKYT 10 sec spot
ATTIC PULLDOWN INSULATION
Переглядів 219 тис.15 років тому
Learn the right way to insulate your attic pulldown stairs for increased comfort and energy savings.
ATTIC HATCH INSUALTION
Переглядів 62 тис.15 років тому
Learn the right way to insulate your attic hatch for increased comfort and energy savings.
Simple Savings Weather Stripping
Переглядів 3,5 тис.16 років тому
weather strip your doors and windows for energy efficiency and energy savings. www.simplesavings.coop
Simple Savings Floor Insulation
Переглядів 25 тис.16 років тому
SimpleSavings:How to properly install floor insulation in your basement or crawlspace

КОМЕНТАРІ

  • @ILLBEDRONED
    @ILLBEDRONED 4 дні тому

    15 years later and this was an awesome find! Thank you!

  • @1GekoKing
    @1GekoKing 7 місяців тому

    Amazing!

  • @AustinMovies
    @AustinMovies 10 місяців тому

    Saved me $250

  • @radhaor
    @radhaor Рік тому

    Brilliant! Thank you Roy

  • @topcat4747
    @topcat4747 2 роки тому

    Thanks!

  • @pearlperlitavenegas2023
    @pearlperlitavenegas2023 2 роки тому

    Thanks

  • @pavelrijinski6442
    @pavelrijinski6442 2 роки тому

    Great video--so much better than the zipper style stair covers that are so common now! You used to be able to buy boxes like the one you made as kits but now I can't find them anywhere, at least not this style. An extra thing I did to the the box is to add two small drawer pull handles to the inside of the short ends, and another two to the short ends of the door framing just below where the box sits on the foam weather stripping, so that I can tighten the box down onto the weather stripping for a better air seal.

    • @dg-hughes
      @dg-hughes 2 роки тому

      Yeah I bought a zipper style one and it's junk. It took me an hour to install it since my attic joists/framing is in the way. I stapled it and used vapour barrier tape on the edges. But the piece of junk leaks through the zipper teeth I can even see the attic light through the teeth. A huge waste of my time and my money.

  • @MrElPoderozo1
    @MrElPoderozo1 4 роки тому

    Just wanted to say thank you for the video. I just got done doing this and it made a big difference, so thanks 👍🏽

  • @howardmaidman1619
    @howardmaidman1619 4 роки тому

    am I missing something here.....I presume the ladder folds into itself unlike mine which slides taking up substantial roof space? 🤔

  • @PrivateChannel1300
    @PrivateChannel1300 4 роки тому

    definitely helps more with air filtration than anything, I imagine the r value is less than R7. Where attics need R38. I'm about to do this myself with a similar technique but filling the box with loose insulation and reenforcing with stripping. also using foam board caulking for joints.

  • @rc6147
    @rc6147 5 років тому

    I had a condensation issue for exactly this reason. I didn't have an insulation box. Good video.

  • @jojo6663330101
    @jojo6663330101 5 років тому

    Great video! Note you may want to use foam-safe adhesive, and many folks recommend using eye hooks to add some tension to the hatch seal

  • @huttarl
    @huttarl 5 років тому

    Thanks for this helpful video. One tip (mistake to avoid): check how much room you have around the stair hardware by going up into the attic (with a light) and having somebody below put the stairs up. Measure the distance between the pneumatic closer, for example, and the wooden frame that you're building your box to fit into. I built a box from 1" foam, and was so happy to go in and install it in the attic... and then pretty disappointed to see it lifted up by the pneumatic closers so that it left a big air gap.

    • @radhaor
      @radhaor Рік тому

      I think I will have that problem too. The metal pieces of the stairs stick up higher into the attic than the folded stairs themselves so it won’t be a perfect cuboid shape.

  • @markryan9364
    @markryan9364 5 років тому

    Great info!!!!

  • @manny2fs
    @manny2fs 7 років тому

    Thanks for the video! I'm going to do this project this weekend.

  • @tomrum42
    @tomrum42 7 років тому

    It is much easier to just glue closed cell foam between the ladder itself and the hatch lid and/or to the ceiling side of the hatch. Be sure to to use the correct adhesive as many adhesives will melt the foam. Use an adhesive specifically made for foam board, which is available at all big box stores. The way the weatherstripping is used in this video is useless due to the fact that the weatherstripping is not compressed.

    • @delldelete2435
      @delldelete2435 6 років тому

      Tom Rumish, I thought weather striping should not be compressed. IDK

    • @areafortyone
      @areafortyone 6 років тому

      That's what I did, glued it to the backside of the pulldown door.

    • @inquisitvem6723
      @inquisitvem6723 5 років тому

      are those foam boards that he is using? can i find those at home depot? this seems so much cheaper than the $50 ones i see sold on amazon where you have use a staple gun and aluminum foil too in order to install them.

  • @Rescuecomputerservice
    @Rescuecomputerservice 8 років тому

    Thanks for sharing this tip. Made one with foil backed board and immediately felt the difference in temperature.

  • @leon8497
    @leon8497 8 років тому

    i been looking for this video all over the Internet 'very happy to see it this information

  • @jonwikan
    @jonwikan 8 років тому

    Great idea, however you need a thermal barrier(15 min fire barrier) above and below the xps foam board as it is combustable. 1/2" sheetrock, 3" mineral wool and any other that meets code. I am dealing with this issue right now and it isn't fun, since each gov agency has something different to say, however not being covered by insurance in a fire situation could be an incentive to check the codes out. In most areas no permit or inspection is needed for insulating an attic, at least after the house has ben built. Were on our own. Good luck!

    • @bobshanery5152
      @bobshanery5152 7 років тому

      Ug Housing codes are at a point that it seems mainly for profit then safety. Everything burns. Use polyiso

    • @mae2759
      @mae2759 6 років тому

      Can you explain why this is needed for fire code? If your house is on fire, what's the difference? Thank you!

  • @TheProclamationProject
    @TheProclamationProject 9 років тому

    While the aluminum tape will do a nice job while building this box, it will eventually separate from the foam (due to the foam, not the tape). The best thing to do is purchase the FOIL backed insulation board. The foil tape will stick to this forever.

    • @inquisitvem6723
      @inquisitvem6723 5 років тому

      What is a good brand aluminum foil tape that will stick to foam forever? thanks.

    • @bobt471
      @bobt471 2 роки тому

      Great TIP! Thank you

  • @teaglet
    @teaglet 10 років тому

    I had mine all built, used 1 1/2 " board. problem was the ledge was 1" so I had 1/2" over hung which interupted with the spring and mechanical hardware.. more cutting..

    • @GeoTime09
      @GeoTime09 6 років тому

      I had the same problem, had to redo my box. Works great picked up 3 degrees of heat in my hallway. Built mine with scrap wood and then insulated it with more scrap insulation. Came in at about 8 pounds but fits nice and tight.

  • @kejb02072627
    @kejb02072627 10 років тому

    I watch a lot of home improvement how to's here on you tube. Your video is excellent, precise and great demonstration on your suggested insulation fix. Thanks!

  • @brandoncooke7223
    @brandoncooke7223 11 років тому

    Thank you sir.

  • @chaksq
    @chaksq 11 років тому

    This is exactly what I need in my apartment. Don't want to spring for something expensive because it's a rental, but can't afford the heat loss either. This is the sort of thing that'll fit the bill exactly. My plans for tomorrow now involve a trip to the hardware store.

  • @marianmana5253
    @marianmana5253 11 років тому

    I have a weakness for following football plus I’ve started earning cash devoid of risk from acquiring bonuses. It’s a strange technique in which you wager on one thing with one bookmakers and bet against it on Betfair. You secure the bonus offer as income . A dude named Jim Vanstone is selecting the bets 100 % free on his own web page Vanstone Secrets (Google it!). I’ve made about 400 quid so far. And it is zero cost. I assume the bookies pay him in order to get new people, but it is effective.

  • @lldrum10
    @lldrum10 11 років тому

    Don't forget to seal around the frame.

  • @loraljohnson
    @loraljohnson 12 років тому

    For those confused about the box: If you listen at 1:10 he states that he used 9 1/2" tall sides to allow for the fold-up stairs to go up into the box. For once, this is a fast, to-the-point, DIY video. Enjoy....

  • @stevenabruno
    @stevenabruno 12 років тому

    Thanks ... Just did and it worked perfectly. God Bless

  • @georgegu2000
    @georgegu2000 12 років тому

    got the point, tks.

  • @Set_your_handle77
    @Set_your_handle77 12 років тому

    I think he just made a box that could be useable by everyone. Different folded ladders might need different heights.

  • @georgegu2000
    @georgegu2000 12 років тому

    A good and simple method. IMHO, can we just make a cover instead of a box (maybe with some foam on the back) as I didn't see a clear advantage of the box space.

    • @inquisitvem6723
      @inquisitvem6723 5 років тому

      you mean just a flat board that rests on top of the attic door right?

    • @huttarl
      @huttarl 5 років тому

      I had the same question. But then I discovered that when our attic stairs fold up, the folded stairs stack quite a bit higher than the level where the flat board would rest. So I needed a box after all. It may depend on your stairs.

  • @goofyGAguy
    @goofyGAguy 12 років тому

    Nice video. I elected to use Liquid Nails instead of tape to hold the box together.

  • @StartInsulating
    @StartInsulating 14 років тому

    Thats is a nice a simple fix but you onlyhave about 4-6" of insulation in that attic. In Wisconsin Energy Star recommends R49 or 15" of blown cellulose (about 22" if using fiberglass). So those boxes create a real problem if you want to insulate up and around the hatch. We build a dam using 2"x12" lumber on top of the scutle framing all around the scuttle to hold back our insulation and then rest a flat panel that is insulated to R50 on top.

  • @toology55
    @toology55 14 років тому

    spray foam is betta