Відео

You sat on a nife

Thanks man! Helped me get in my trunk.

I can’t believe we can’t do this from the outside

Watching this in 2024 cause I need to change mine out. How many miles is on your tsx. Just wanted to compare to mine cause I got a feeling my mounts are just as bad.

Thank you... acceleration issues?

After bled you just put the cap back on hot?

The 17mm trick saved me 😭

So i replaced the cable but the motor doesn’t seem to work. I checked it on the other cable and it’s fine so is it wiring that’s bad?

Where I can buy the seal ?

Good

In case anyone needs to know what the socket is for the top transmission bolt ua-cam.com/video/KYjb3zKaBxQ/v-deo.htmlsi=Z5nHi7aPqrAGyj9L

Thanks

What's special socket for tight the bolt.

Bro you are the man. I have been having issues for months. I had no idea that was there! Thank you!!!!🙏🏽💪🏽

Good lord! Thank you! After days of trying to figure how to get into my trunk!! Sheesh

Thanks for posting this tip. You are awesome!

A/C??? Supposed to turn on heater

That’s hot

Thank you for the help man

This video helped a lot thank you

I have same break set up ✊🏼

Bro how can I get the bolts that hold the braket on the motor ?

This is so wrong just unlock it from the inside open it from the outside

😂😂😂😂

Worthless

Thank you very helpful

Parts fail inevitably, and I understand but what would you say if I replaced my front and rear bearings in a span of 2 years? 🤔 I have a 09 tsx and I got hit with the abs,vsa, brake light come on.

Seems those mounting holes for B20 are weak.... Same here

I know your posting is over a year old, but it has just helped me out immensely. I changed out the other three mounts, but was stuck in limbo with the rear mount until I came across your video. Thank you very much for detailing how to attack that elusive 4th bottom bolt, and the order of removal. This video is the best!

I wish I had a dollar for every time this guy said stud 😂

I think That rotor goes on the pass side

Thank you for knowledge I appreciate you

Was your steering off when you replaced it ?

You don't have to remove the butterfly, only let it drain for 20 min and screw it back. Prevent the mess!

Just called out of work because I couldn’t open my trunk…. Such a stupid design by Acura

Thanks a lot,, you saved our life ❤

How did you bleed the system afterwards? My asc doesn't have a cap on the radiator

I'm having the same problem on a 2015. By chance was your code p0068? I am getting that code and the car will run but goes into limp mode and ends up stalling. Then it is hard to start. I loosened the clamp for the hose going to the air filter. However, I cannot get the hose to come off to give me access to the throttle body to clean it.

Can you clarify which steps you added water and which steps antifreeze?

Ty For this video bro 🙏🏾 God bless you

What was the mileage of when you replaced the rear mount?

Thanks! Great info!

Whats the mileage of the car when you replaced the mounts?

What is the torque setting for the steering wheel nut

You just saved me a huge one!! God bless you

Should i change transmission mount too or just engine mount.

Should i change all 3 mount or just one like you changed.

Can i use accord 09 wheels bearing to tsx 2009.

Cool dog❤

Do you need to run the AC or the heater? You have to run the heater to allow coolant to go through the heater core to get the air out no?