Відео

Hey question for you so I jumped the two wires and instead of crank no start it fired up and ran just didn’t stay running it runs for about 10-15 seconds then sputters out and dies just curious if that’s the same thing that was happening with you? I’ll most likely just buy a new module and see if that fixes it but wondering if there’s more to it like a pump or something.

Where's the module located

I have a 2010 vauxhall insignia and when stationery and driving i hear like a jingly noise, thats the best i can describe it, its getting louder by the day, its coming from the side of the engine where all the pulleys and belts are?

The back clip wont budge so my reservoirs just stuck

how high off the ground does the car have to be? Do you need a lift, or will ramps work?

I changed resistor, checked fuses and relays. Fan still won’t turn on I jumped the fan itself (no resistor attached) to the battery and still won’t turn Do I have failed fan motor?

aint no axle nut with the tire having play, that is always a bearing

Thank you 🙏 works

Charged me for a fuel pump and few days later it was doing same thing looked on UA-cam changed fuel pump module cranked right back

Motor mounts died long before you alternator started giving out… PLEASE REPLACE YOUR MOUNTS Hard to believe this is a 2017 when its engine bay looks just like a 09 Camry with +250k miles and no maintenance…..

What about the fan?

Do i have yo refill the AC ?

The coolant can short something out? I had to add coolant before this issue started w me. I’m trying to figure out my situation thanks!

What are the symptoms of this being blown?

Good video but I sure wish you would have included the most important info like how to disconnect those leads to the battery fuse.

What tests should I do to make sure this is the fault?

My dad has a '04 LeSabre & since I mostly drive it (my 96 corolla don't run at the moment so I'm using the Buick) & one morning it developed a misfire & even though all plugs, wires, & coil packs were replaced, it still misfires & I'm not sure why

Thanks 🎉for Sharing

You didn't show anything.

Omg a lot of work

Had to do this in 2019. Part was $23. Have to do this in 2024. Part is $44.

I’m having the same exzact issue with mine rn but new starter and it’s still not working

Great video

The negative cable on the postive you had 2 postive cables on it som I'm asking will a negative cable work how u did yours

Th

Do positive and negative work

Both of mine are somewhat loose. After I jump the car it only stays running a few seconds before dying on me

What good is this video

Hey brother, how did you put the new one in? From the inside first goes through the hole then out?

Cool, thank you

Was that the 2 positive hooked to the positive terminal?

I had a misfire on cylinder 1 but it comes and goes. Some days it’s there, sometimes it’s not.

i’m trying figure how to adjust the rod for the switch

Literally the only one with the same code I’m happy I found this are you in Dallas I need this

2004 accord lookin like a crv

#Ford have had to replace 5 times already!

We know its broken. How do you fix it ?

same codes for me and that’s correct my truck started bk up. thanks

Thanks men!!! Really preciated

Why does this look exactly like my car... leaves and all 😂

I have a no crank but all the ligts and accessories work and i get a slight buzzing sound when i try to start the car. Could this possibly be the reason and what i need ro replace? And can I see if the fuse is broken without having to remove it

I don’t understand. I disconnected the clipped part where the wires are but when I twist the headlight doesn’t come out. How are you twisting?

I had that issue a few year s back now I have a p0402 and I change egr solenoid deltal pressure ext and car still stalls

What is with these cars? I've had a few good bad in the past few months

Good thinking. Test drive went well. If anything changes I will DEF update everyone!

a dumbass rewired that and used the incorrect connector

Need to figure out why the wire is getting to much power causing the melt first

Great video thanks bro

Ohio

can manually do the job, you just don't tell the truth.