Відео

By transducer output voltage or M-amp check analog voltage by max and min volt or 4-20 amp out aapko max 10 v Tak or4-29 ma milega usi se pressure me divided kar do , wahi limit hoga jisko pressure me measure karte hai

Most welcome

Again watch you will below and top red arrow thanks

Sure

Dear , step out put ke liye loop line wire (phase) connect hona chahiye aur maybe kuch step malfunction kar rahe honge to 0-9 all step manual me check karo , aur error alarm show ho rha hai to alarm code se troubleshoot kar sakte hai

Thanks & please share with your colleagues to support this channels for letest updates thanks

​@@gajendrapandey5202 definitely we vl

Sure , please share with your colleagues as well thanks for your opinion

@@gajendrapandey5202 sure sir

Thank you for this video Engineer gajendra it is so helpful and detailed.

Thanks for your support, I have already uploaded those videos please share with your friends

Thanks

Then check your connection ,AI potential should work by 0-10 v if this is ok then check parameters where you applied 10 put 7. Otherwise check hardware also you can share me your WhatsApp for all conversations to short out the issue thanks

If you are running through DI then set your voltage accordingly with HZ and potential should reach on 100% as per the maximum speed set point

Hz can only 50 or 60 percent can go up to 100

Sure

Aap Numbers share kar dijiye mai msg krta hu by WhatsApp

Check PO731 fix 53.3 if not then fix 53.2 if setting are ok then check inverter internal DC fuse

In P732 r2815.0 setted how it works please explain

Is method me plc required nahi hota hai if you need variable then use potential controller otherwise you can select 3step frequency for D1,2,3 to use H M L speed

RCCB tester

Hi thanks for your comment, can you write in English please

Available by local dealers according to country areas.

What is price at your place?

@@veerveer5197 in Germany round 110 $

M a ka vi bataye mean ?

@@gajendrapandey5202 4 ma to 20 ma analogs input and output ka parameter setting bataye

@@nawalkishorkumar9947 Aapko parameter P0756 me 2 set krna hai after aapka AI 1 input MA me ho jayega , agar 3 rakhte hai to monitoring with ma input ho jayega dono ek ek kar ke results dekh sakte hai Thanks

Sir p0756 me 2 dalne ke baad me bhi nahi hua please aap ispar 1 video lade

Thanks for your question , go through the below for your question . P1300 put 7 which is for V/F mode. Mean vector mode which can run multiple motor. Set total capacity example: 2amp+2amp+2amp= set point in 6 amp same calculate KW then put 20%extra KW # All connected motors will be run in parallel individual can’t be control. # must be cable pass through output protection such as MPCB etc. # If your MCB tripping that mean overload short circuit # If MCCB tripping means leakage, short, overload (check ELR,cable motor winding and breaker ) # If ELCB tripping means current leak. # for motor speed can be variable by AI, DI by same parameter as the video .