Відео

Hey man i just installed my stage 2 camshaft after installing it started for few minutes and then it stalled and could not start it again, so after looking and checking we loosen the tappet then it started and now there is a bad tappet sound, how did you fix it. Mine is 4v

Any upgrades in cooling system with this ..?

thanks man, very helpful

Please share the garage address,i want to check if the old GT single cylinder 535cc bore can be fixed on my Himalayan

Size of cam?

my stock xpulse goes 135+

the cat taking all my attention not able to focus on bore kit

Where did you get in done, give details of garage and parts.

4V ?

Bro can i install this kit in my pulsar 220

How much is the fastest cruising speed?

Bro from where did you get that headlight coul? 🤔

Engine khul gya Bhai ab to 😂

Bro how the fire comes

What you used for coating?

Do you have quick throttle on that bike?

Do you still use bb kit? If you dont What is the problem? I want to buy 241 cc bb kit my 2v but I am not sure

Bro how it’s going?like any issues? And how much are you u able to drive it on? I mean cruise on on highways

I always worry when increasing HP - the entire bike has been designed around the original power output figures and even after only travelling 10,000kms on my BS4, I have always found the power of the 411cc sufficient if the gears are used suitably. However, best of luck with this conversion and it’s long term performance.😁👍🇦🇺

Están bueno el vídeo, saludos desde Colombia.

Nice video.... Will you please share a link to buy the big bore kit??? Thanks in advance...

Where are review videos bro?? No xpulse review no himalayan review waiting for it.

Where is this service center?

Topspeed now??

Topspeed after big bore kit??

Please do update on this. We are all eagerly waiting. Or reply in comments. 1. How is the reliability? 2. How is acceleration? 3. Top speed? 4. Fuel economy? 5. Any ptoblems faced after install? 6. Total cost of installation

Bro top speed

Bro make race between big bore nmw xpulse vs. Stock xpulse small video

Wow! I want too!

nima number send it

Abi speed badgay kiyaa...

How much amount

Please show the topspeed do a topend race

If the factory had wanted it more powerful, then they would have made it so It has been tested for hundreds of thousands of miles. For reliable running. If it is not broken don't fix it. It is what it is , don't waste your money. Big power hike.bigger problem. Leave as is.

semma 👍

Lol " the bike is flying " Great job - best wishes from the U.S. !!!

It's been six month now waiting for a new video from your channel. Hope everything fine.

How much it cost bro please can u give me your phone no.

Bro what's the top speed on big bore you got

No more update bro

234cc with just 15hp? Man, that's just too low.

Bro can u please tell the cost you’ve incurred.

Hey. May I know the handle bar you are using? I have a rally edition and looking for a suggestion.

More the cubic capacity, more the power.. Also gearbox differences matters a lot..

What tires are you running? Looks good. Are they stock?

What kind of idiot gives a new set of rings full bore?

An interesting video. Not a job for the faint hearted. Or the noe technical. Thanks for posting.

Bro this is krishnagari

Stage 2 camshaft High tension clutch springs RCB hydraulic clutch kit 12/40 sprocket & brass chain Powertronics ECU & EMS from Race dynamics mapped & calibrated Ceramic brake pads and steel brake lines Quick throttle Barrel exhaust thrust muffler (Optional, would also require a dyno tuning). I use stock exhaust and strip off weight from other areas of the bike BMC air filter (Make sure to remove the filter intake cover) Use Reise TrailR's if you are doing both On & Off road

What is the top speed?