Відео

Hi Bryan, that should work, if you print with lightweight pla, but i used a 4 S 1300, i found the gear a tad too flimsy, especially on a grass field, best to belly land, i used the standard flitetest setup, it would be a rocket on a small 6s, nice flight characteristics once you get the COG correct

Pla flies fine, just keep it single wall, that first plane was twice the weight it should have been. It does have a brittle factor to it, but balsa does the same on impact.

3S 1500mah lipo, or a 4S 1300, but the 3S has plenty of power, typical flight times, 8-10 mins, I have never flown it to the point of cutoff.

@@electricrcfoamflyer Thank you!

Joshua, what kind of additional info are you after, it was part of a walleye/sturgeon restoration project as a way to monitor spawning success on the newly created beds. The Matt’s were a blue furnace filter medium readily available at the hardware store, anchored with rock substrate

@@electricrcfoamflyer Thanks for the prompt reply. I am currently a student at UW-Whitewater doing a research project on whether or not walleyes and northern pike spawn on Whitewater lake. I've been doing a lot of research when it comes to what kind of methods we could use and the use of mats came up. Would this method work for the northern pike as well? Does it work on a Lake? How often did you check the mats and was it in your mind a successful way to monitor spawning success? If you answer any of these questions I would be thrilled. Thank You

Joshua Versh , I am Aquatic Ecosystem Fisheries Science Specialist with the Ontario Ministry of Natural Resources, I have spent 25 years doing walleye/ lake sturgeon restoration and large river work, so give me a shout if wish to discuss some more, 705 235-1215 will get you my office line.

3inen 21 yes please let me know, would love to do that