Відео

اريد طريقة تواصل ياهندسة لضرورة علمية

02:47 Simulating using solid models is smarter and closer to the correct result. In this way, connection breaks occur in your model. and the simulation would not be healthy.

How do I determine the speed of the model? For example, I want to test it at speeds of 30 km/h, 60 and 100.

how can I contact with you? from Iraq

Very useful. Thank you sir

For PI, will P output be added to I output from t = 0, or P will start controlling first and then stop, at this moment with SS Error,I will continue to eliminate the SS Error ( without any contribution from P)?

A great and simple video. Thank you!

How would we use compared with a PID controller

❤

What are the advantages of S domain in comparison to Time Domain?

Super clear, super concise, thaaankyou!

easy to understand to the point

I had this problem of not saving my settings for weeks! Thanks for helping me out! It was starting to get very annoying hahah

how in a program this expensive, can there not just be a program wide setting: Default to x standard

can i ask you for help with design steering system

Hello, I get an error stating that the sketch is over defined, and apparently the problem is the length of the spring, any idea why that might be?

the rectangular piece is not still aligned with the line, when turning the lever the rectangular piece also rotates circularly because la pieza rectangular no sigue alineada con la recta , al girar la palanca la pieza rectangular también gira circularmente porque

Thank you. Your explanation of subplots is great! Many make explanation difficult to understand using difficult terms to understand. IDK why. Thank you

What is “T” value range?

يعطيك العافية

thanks. but it shouldnt be this complicated..

حياك الله احمد

Thank you so muchh

Brilliant work!!!!

it really helped! thankss

Hi can you send me the files? Thank you

💝

thank u

The best explanation ever I can't believe it I understood it immediately Your a wonderful teacher 💥⭐⚡ I rate you 5 stars ⭐⭐⭐⭐⭐ All my friends see this Thank you very much 💕

I am so speechless when reading some explanations, not helpful and just making problem more complicated. This video is awesome, thx a lot!

Thank you very much, It was really helpful

Really its helpful for me..........

Thank you for the video. Can we add friction forces and torques to joints ?

Thankyou very much

well explained !

ماشاء الله برنس يا بشمهندس , جزاكم الله خيرا , Well prepared and fruitful content ,Thank you

Tsm

Check out All About SubPlot in MATLAB ua-cam.com/video/PExZqewAbe4/v-deo.html

Thanks!

thank you

if possible, could you use texbook problems and answer them, or just any problems in general so i can fully grasp the steps

4:43 why it move to the right initially?

thank you 💕💕

What if i want to change the colors?

hi Ahmed, this is really great video.. I designed a basic quarter car model at simulink with PI Control but the resulting output of a circuit that uses a controller and without a controller get the same value.. can you help me solve it, i have made the circuit and i can send it to you by email

great video nd helpful

What type of steering geometry are you using? looks like anti-Ackermann but outside wheel doesn't seem to be turning more than the inner wheel.

Thanks man, god bless u

Amazing job! Would you mind to share the drawing file as I am currently developing a simplce vehicle model for simulation for final year project, it would be very helpful to me. Thank you very much!

i subscribed you on Sunday 20thfeb 2022