Відео

RE touring seat

@@gadgetwheelz Thanks YOU. Great job!

​@@gadgetwheelz With stock Seat can you install a COWL like YOU?

No, it's a GT touring seat which has a provision for cowl fix

I jave used once, for me Brembo is far better

@@gadgetwheelz stock brembo pads are better than these ebc double H pads?🥲

I never tried EBC again so I can't conclude which is better. For me Brembo pads lasts for more than 15K kms

@@gadgetwheelz got it bro, for me longevity of the pads doesn’t matter as long as im getting superior braking..was the bite better than brembo ones if you can remember? TIA

No, but it didn't last more than stock RE pads compared to it's price.

No, it doesn't. 30L capacity with compact design

For me It last less than Brembo pads, usually Bembo pads last 14-15K kms.EBC last for 11k.

Top rack 10k and universal plate 4.5k

It's straight forward, you just replace the Baja switch with Switch pro. Switch Pro comes with both male and female connector.Just fix the female connector to Baja switch wire(you need to cut the Baja wire) and good to go.

@@gadgetwheelz Okay, thanks!

City ride 24-25kmpl , highway 30-32kmpl

usually at 1300-1400rpm Aftermarket exhaust does not damage the engine.

I have used both FuelX pro and Booster plus.Both serves the same purpose, FuelX pro is bit complicated as compared Booster Plug.I am using Booster plug again without any issues. You wont find any major difference with the performance.These are not performance boosters, just manipulate the air fuel mixture and adjust the low and mid range performance.You wont find gain in Horse power.

Buddy, I bought it from www.way2speed.com

I am using WD 40 only for lock sets not for rubber parts. But if it comes in contact with rubber parts, I dont think it will damage in a large extent.I am using it for more than 4 years on my Interceptor. Rusting on bend pipe is a major issue.You cant avoid permanently unless you replace it with stainless bend pipes. Fork pipe cleaning i am not using any special cleaning agents.Just car washing shampoo. Greasing the bearings are done at local mechanic. I use nylon thick wire to clean the Fuel tank water drainage pipe Battery terminal usually cleaned by my local mechanic

I will try to do.

No I dont have, but is very is to install on Bark Busters hand guard A template is given in the box to make a proper fixing position of the lights.

@@gadgetwheelz can I talk to you on phone Sir, if you do not mind

@@gadgetwheelz can I talk to you on phone Sir, if you do not mind

Baja design light comes with wiring harness which is waterproof.I am using it for more than 4 years now,no issues.But switch that comes with baja is very tiny so I replaced it with Magdog switch.

@@gadgetwheelz Yes. Will stick to the harness then. Will get the Maddog Switch Pro! Thank you!

Quality of the music is decent . I would rate it 7.5 in a 1-10 scale

Phone Call OK Music MAX 5 - 6 I wouldn't buy it again

I definitely go with Booster Plug because it's a simple setup and you can easily remove it whenever issue occurs. I used FuelX Pro for about 2.5 years (with FuelX Pro I rode around 50k Kms)during that period I replaced thrice under warranty. It's bit complicated set up and comes with poor wiring harness. Fundamentally both product serves the same purpose but in a different way.One works with AIT sensor later one with O2 sensor. Performance wise no drastic differences.

@@gadgetwheelz Thank you so much for the honest reply. I use BMC Air filter with Stock Air filter cover, Sound changes at 3k RPM and I noticed a mild better throttle response. I might add a power rage slip on and I am thinking of adding a Booster Plug or maybe a Powertronic if possible.

There's also the Wavex foam 3 sprayer now, confused between the three.

Dont buy Shine X Pro. Though the quality is good, spray is not effective after few usage. Try something else.

@@gadgetwheelz Thank you! I have seen positive reviews of the IK foam sprayer but it's a little expensive at 3.5k now. I think I will get that! As they say "Buy it nice or buy it twice". Thanks for your input

@@gadgetwheelz Hi, I'm considering getting the Baja Squadron Sport lights for my Speed 400. You have the Pro lights right? How has the experience been with them?

@gurucharanchundi , I am using Baja Squadron Pro, there are very powerful.

I bought it from local RE genuine spare part vendor in Mumbai

😀😀 why bro?

you can use either adhesive or clip on.I am using CLIP on my modular helmet

@@gadgetwheelz awesome was shooting more on the clip part and I’m assuming have to put clip further back due to the slide button for the inside visor 😎

within a week

Helmet wont fit in that Givi topbox. RE deluxe seat is much better than RE's stock seat

Yesss..😀👍

with any connected phone .

To be frank those are not that great. I hardy used it for 2-3 months. The black part is very flimsy and fitiing also not perfect.First order I sent back due to poor fit and finish .Not recommended

​@@gadgetwheelz thanks a ton!

it doesn't come with carrying handle.But you can buy as an accessory.Givi strolley carrier

NTN Tapered roller bearings

True , if you own one keep it as stock.👍 I won't recommend any kind of modifications 😊

25k

Yes

That's anti-rust coating 😀😀

Not really, but it should be run in the background

It's a personal choice right? My Interceptor clocked 80K plus kms

I haven't done PPF .

Thanks, black also looks awesome.

appx.34k

34k

you can use other top rack, but you need Givi base plate.

I bought the tank cap collar from www.way2speed.com