Відео

I have an Giulietta and a Ctek charger. But no mather wat I do, after step 3 the Ctek charger goes in error and gives a red light. any idea?

Considering these are some of the top hardest ones to restore, you did pretty good!. These require a good amount of 320 grit to remove all that old clear coat and scratches, since Kia's clear coat is has pretty stubborn hardening properties. This is why you can see that line where the old clear starts. Definitely better, nice job!

Can you post a video where to buy it

Doesn’t actually work, since when the boot lid is fully open, the spring is fully contracted….. get the updated spring from Alfa Romeo

Someone literally just gifted me one of these Alfa Romeo battery tender after my battery went out….. I felt so blessed thanks for the video

Part 2? 😢

excellent!

The Carbon fibre bits…….did they come standard or did you install them as aftermarket?

What were the results of the Oil Analysis? Can you post the results? Thx!

Great video, I was trying to figure out where to connect to power without going through the firewall and your video solved that for me. I assume this turns on and off with the lights? Also how has the installation held up overtime is the adhesive holding it in place well?

The sample should have been taken from midstream, and not from the filter. Would give skewed results

Thanks a lot! Just used this video to attach my ctek

These look clean, how are you liking them six months later?

You can connect on the front

Great video, thanks for sharing. Southern Hydrographics has sold out, any recommendations on other carbon fiber clear hydrographic films? Thanks

What's that pattern on the tail lights, it's quite striking!

Thank you for the video :)

Thanks! I've had the trunk lid hit my head when the car was parked on a slope. It hurts when you don't have a lot of hair on your head to cushion the falling trunk lid. I brought it to the attention of the dealer and apparently there's not a technical bulletin on this. Great fix!!

perfect, because I couldn't close my trunk.. TY

Hello Karl, I am having that same exact noise in my 2005 crossfire. how did u fix it?

Karl, my V is black. Any recommendations on making the light strip a dark color so the strip isn’t too visible during the day?

does this work on 2022?

Where can I buy this kit ?

Could something small like this void my maintenance warranty 🤔

Love the video. I wish you lived in Houston Tx. So you can do my wife's alfa romeo stelvio. Keep up the updates on the stelvio. How's the V- light kit doing now.

Did you disconnect the battery too or put fabs over 30ft

For the price of the car new, that is the worst engineering piece of junk I have ever seen. I've seen toys that are more durable than that. It degrades the value of the car.

Hey Daniel, Thanks for the detailed video. Am new to the hydro dipping and wanted to know the primer name you used for the low gloss spray… Thank you!!!

great video, THANK YOU!!

Do we need to disconnect the battery?

Great video, I'll have to copy you on the dip method. Your light strip is much longer than mine. Did you get the Stelvio one? Mine ends right with the stiletto.

what notch are you referring to I cant get these to lay flat in the frame

My trunk sags even without a rear spoiler and I’ve hit my head a couple time so I will try that fix, I think that was very smart hopefully it works for me

Good f****** God! Why didn't you just buy speakers that fit in the first place?!

Thank you sir

do you leave the trunk open while charging, close it on the cord, is there a trick? thank you.

Ctek do sell a lead that fits an M8 stud - it cost me $15 in Australia - saves drilling/cutting/soldering.

Why did they make it so hard to keep the battery charge at all time when store in the garage? I used to drive a corvette c7 and it has a port for battery charging I wish they had this feature in giulia qv. I only drive mine like twice a week

Your logos are the opposite way round🤔 surely the rear door is the correct way round?

Real helpful - thank you.

Dude you're full of shit those fucking speakers don't fit after I did the cuts and mounted them into the holders they don't even fit into the damn holes and then the same model that you said to get

An easy repair is remove the retaining spring on the side The cup holder will still work just not automatic must open manually

You did a nice job but that unit is not well designed for an Alfa since it does not fit correctly without drilling out the eyelets and since the clamps don’t fit from the positive and Negative posts under the hood.

I have two other videos on UA-cam. Search for Alfa Giulia logo lights and Alfa Giulia trunk lid sag fix.

I have an SRT 6. The Crossfire is a great car except for two things. The goofy wing that comes up and down. That's why I like the fixed wing SRT6. The other thing is the cup holder. It is in the wrong position right under your arm and IT DOESN'T HOLD ANYTHING. Stupid thing to put on such a nice car.

Why couldn't you heat the plastic and remold it so it stays sealed ?

torque numbers to put it back together??

How does it sound..?? Was it worth it??

Karl. I was tirelessly looking for somewhere to place my sub then came across this video. I actually have the same exact sub. Got to the end of the video and couldn’t locate part 2. Please update us on the cutting and the final install. At some point I found my stock amp and it wasn’t functioning, took it out. Will this setup require another amp?. Thanks.

I just ordered those speakers and I'm doing this to my 2006 Crossfire. The speakers haven't come yet but I'll post how it went. Still concerned about cutting the bracket properly. Thanks for the red and grey wire + designation that is a time saver and also that they'll work as is without sodering.