- 9
- 5 129
Jeremy Goldman
Приєднався 22 січ 2010
85 Grand Wagoneer Instrument Cluster Repair
Removal and replacement bad bulbs, detached lens, and cleaning of instrument cluster.
Переглядів: 4 242
Відео
Hillel's Man of the Year - Bob Goldstein
Переглядів 907 років тому
Pittsburgh's Hillel Academy honored Bob Goldstein, CPA for his help in raising over $750K!
Airedale puppy dog and adorable baby playing together for the 1st time!
Переглядів 3547 років тому
Penny the Airedale loves her baby sister so much that she's teaching her how to use her play mat.
Rolling back odometers it not only illegal, it also leaves evidence because numbers even showing less miles, wont look aligned
I just found out you already answered that, thanks any way!
Hello Thank you very much for your video, it has encouraged me and helped me to make a repair of that indicator panel since one of the micas also peeled off when cleaning it. Thanks to your video I was encouraged to make that repair and your video has been very useful. Just a doubt, when you were removing the defrost section, there is a lever to select the temperature (the one below), which has a button on the metal part, my question is, how did you remove it, in my case it seems to be glued. Thank you very much for any advice!
Good video. I'm doing this on a 1982 Cherokee. Eager to see the follow up to this. Did you need to repair any connections on the circuit board where the circular plug attaches?
How’d you screw that speedometer cable off? I can barely get my hand in there haha
It was a little tough. If I remember correctly, I used my right hand to unscrew the cable and my left hand to maneuver the cluster
Remove the glove and/or ashtray. Easy to reach in there.
If you could keep making videos about this car that would be amazing because I'm currently 16 about to get my license in a few months and this is my first and I just wanted to fix mine to perfection
How did you removed the heather from the cluster? I can’t remove the cool warm button that is the thing that don’t let the heather go out
The button just pulls off from the sliding lever. I think. I'll check tomorrow and let you know
Sorry for the delay, but yes, the "knob" just pulls right off
Actually, you don't have to remove the heater/blower controls. Mark the vacuum hoses and then just pull them off. You'll see the cable connection to the blend door. There will be a push on clip holding on the lever. Use regular pliers and it pulls off easy. You may have to work the cable end off of control lever/arm Next, there's about a 5/16 bolt securing the blend door cable shaft to the heater control assembly. Remove that and the cable will drop free. You can access all of this with cluster partially out. Believe it or not, i removed all of this lying on the floor reaching up under the the dash. But that was 38 years ago. I'm currently working on a 74 j-10. It's the same cluster. Someone has made a mess with the wiring and i was hoping to get a glimpse of the back of the cluster and where the plug connects above the ampmeter. The wires are pulled out of the connector and i need to see which order that they go into. I suggest 2825 bulbs for the cluster. They're a little brighter than the 194s