- 9
- 32 904
subramanian p
Приєднався 20 бер 2013
CSWIP 3.1 Chapter 12 MMAW
In this video i have explained about MMAW Welding variables current ,Voltage, Travel speed, Welding Consumables, Operating factor, Duty cycle
Переглядів: 141
Відео
Cswip 3.1 introduction of welding process chapter -11
Переглядів 1312 роки тому
In this video i have explained about introduction of welding process heat input, voltage, current, polarity, power source characteristics (constant voltage) (constant current)
How to draw DAC by using using 19mm SDH block70 degree Olympus Epoch 600 Ultra sonic flaw detector
Переглядів 15 тис.2 роки тому
In This Video I have explained How to draw DAC by using 19mm SDH block with 70 degree angle in Olympus Epoch 600 Ultra sonic flaw detector
surface profile measurements calibration by using surface profile needle gauge
Переглядів 1412 роки тому
in this vedio surface profile measurements calibration by using surface profile needle gauge
surface profile measurements calibration by using dial indicator with replica tape
Переглядів 1,5 тис.2 роки тому
in this vedio i have explained surface profile measurements calibration by using dial indicator with replica tape
Ultrasonic angle probe v2 block calibration by using olympus epoch 600
Переглядів 16 тис.2 роки тому
in this video I have explained about following calibrations and how to use the olympus epoch 600 flaw detector exit point range calibration verify the angle of beam & sensitivity
Why you didn't minus 50 micron from the showed value of 170 micron
Hi, do you provide practical class
You draw the wrong DAC because when we select the first point at reference dB we can't change the reference dB for another point. And in this video you change the dB for the 3rd point so it is not acceptable.😮
Good day, pls do you have any reference site where i can get correct and detail tutorials on Olympus EPOCH 600?
Yup you right, Can't change the dB reference..
@@sanisaleh2421You wan setting Olympus 600? I have it
very good sir
What is the surface roughness.
Blasted profile
good
Hello, my name is Carlos! His videos are excellent, do you have any tutorial on how to use the epoch 600 DATALOGGER?
V2 block 70 degree angle prope calibration hole of depth 8mm or 7.5 mm?
7.5 mm
Thank you first time am learning with your teaching
Navigation Pas is good or Knob Configuration which is good for site work and Training
Last point you taken not a 1+1/4 that is 1+3/4...
How to change in to mm please tell me sir
Hi bro can i get your watsapp number I'm also a painting and blasting supervisor. So i just want to clear some doubts.
Anyone know of any companies that make protective cases for the epoch 650? We have 2 cases from 7 years ago when we bought our scopes but can't seem to find the company that made these or any company that is making them now. Can anyone help?
Thanks for your helping.. Please make for VI block calibration.... Also defects and how to sizing
Thanks shortly will upload
Thanks a lot
Very Informative. Thank you for sharing knowledge.
Thanks for the video sir
Most welcome
Please send video DAC 19 mm SDH Block olympus 650 machine
Uploaded
good very usefull