Відео

Hi, does the round lens at the bottom center also burn by low beam (when the motorcycle engine is started)? Or is this round lens at the bottom center only for the high beam?

Did your bike vibrate more with the crash bars fitted ? Thank you

Nice done! I will try it next week. Thanx! Greetings from the Netherlands.

Great job! How tall are your red racks?

The scruw doesnt fit in this new led light. Please somebody help. The holes on the new led light is somehow too small for the scruws

Thanks for sharing. How much to you think they weigh? I’m not really keen on how it also bolts to the engine. Do you think it dissipates the force in a fall so it doesn’t damage the bike at the mounting points?

Thank you. Your instructions were spot on. I had nothing but issues with the lack of instructions that come with bars, very poor. You pointed out where you had issues and made it much better. Thank you

Are they legal?

Is this the short rack?

I just installed an LED headlamp in the stock headlight housing. It's the same bulb that's used on many cars and trucks. It seems twice as bright as the stock halogen bulb. I also installed an LED parking light bulb. That's the small bulb to the right of the headlamp. It was probably twice as bright as well. I installed four amber LED bulbs in the turn signals. They seemed three times brighter and were drop in replacements that didn't change the flash rate. I bought all of the LED bulbs on Amazon and they were not expensive. I didn't remove any fairings. I removed a cap screw on each side of the headlight assembly and with a little persuasion, it popped out the front. The user manual describes replacing the bulbs. I also wired heated grips, a dual USB charging port and a hidden Invoxia GPS tracker cable tied behind and above the headlight with a separate USB charger to recharge the GPS tracker while I'm riding. The two accessory power ports from the back of the LCD instrument panel have a weird connector. I bought the mating connectors on eBay. I replaced the three rubber mounts on the headlight mounting bracket with large washers to hard mount the headlight to eliminate the horrible vertical vibration that causes the headlight to flicker. There is no need to shock mount an LED headlight because there is no filament to break.

it is an early sign of faulty starter motor, i had mine replaced, nice looking bike but with tons of electronic issues 😩

What was the modification you did to the pull-up bar?

Awesome work. How tall are your uprights and how high is the pull up bar off the ground when in use. I have 8 foot ceilings and I’m considering cutting them down to accommodate the low ceiling

With the rack folded against the wall, what is the dimension from the wall to the outside of the kipping bar?? I like that set-up, but I've got an attic hatch that's about 18.5 inches from my wall. Wondering if I can still open the attic with the rack folded against the wall

Hi man! for the DRL did you connect BOTH the GRAY and the BLACK/WHITE cables from the factory BMW connector (all together) to the Red Cable... OR... did you only connect the BMW GRAY cable to the TOPLITE red cable (and did not use the BMW BLACK/WHITE cable)??

Hi can you please create a video blog explaining the LED light experience. Showing, High, low & DRL....

and g310r??

Did the 3m sticker and the rubber a good job for vibrating?

Would be great if you can do another video in more depth on what exactly you did. Thx

Hello just talked to prx and they told me this rack does not offer west hole spacing (1")?? Been reading a lot and some people said they had to put something under bench to adjust their bench for benching because they dont have west hole spacing?? I have read this is one of the most important features of a rack?? Will it be an issue if I purchase one of this prx racks ?? I have a full rack right now with west hole spacing and I can see why is important when bemching

Do spotter arma get in the way of benching? Does barbell hits them while benching?

How many inches do you have between wall and rack? It looks fully extended. Did u get 90" rCk?

My ceiling is 8 feet and 1 inch. 97 inches total..so I guess I will be OK installing a multi grip bar..my only concern is that when u.fold it is to close to wall?

Is there enough space behind for a spotter?

Hey Johnny Great job. Thank you for the video. My ceiling is also pretty low. If you don’t mind me asking how tall are you?

Bro.. Need your help. I installed this light DRL not working. Low and High beam is working. I thought I plug the red wire wrongly. I pulled the connector and turn it 180 and plug it back then switch on the motor. Regretted my action. My headlight and rear light now not working. Signal light still working. Did I just pop my fuse or the headlight is damaged? Please advice. Thanks

I have my cealing at 8’4” so good to know it will fit.

hi which rack is this? the profile or pro?

Where is the pull up piece from? Did you get it from the PRX site?

could you pls expand on how you fixed the connection that has only one cable (red) instead of the 2 that comes with the stock?.. at the beginning of the video

HI yeah, how did you connect the running light wire? Where did you connect it?

Looks great man. Good job!

Hi.how did you connect the drl lights.it has only one cable

its fantastic sir. where can I get one for my 310 gs? pls, share the details.

Thanks for the upload, keep up the good work!!! I really think that you deserve more views. Have you ever looked into using followsm . c o m??? You should use it, it will help you get the views that you deserve.

How low are the ceilings?

not a good idea two pack all that weight on top of your trunk, the spoiler hole sometimes split from the wait and is not cheap to replace...

Wow!

Nice😉. The wing wins again. I see you have a black trunk rack, where did you order that from if you don't mind me asking. I'm looking for a black rack. I'm trying to stay away from all the chrome.