![bansheeman69692005](/img/default-banner.jpg)
- 32
- 13 520
bansheeman69692005
Приєднався 13 січ 2008
Відео
Milling New Gantry
Переглядів 76 років тому
This is the main support for the new gantry.. It's oak, 3/4". This is the rough cut. Doing tool change and finish cut with a 1/8 ballmill.
CNC Router Test
Переглядів 186 років тому
Just a video of my CNC router making it's first run with simply an ink pen to test for accuracy.. Its unfinished..
custom built shop press pressing together ds650 crankshaft
Переглядів 1,7 тис.8 років тому
Description
My Cantilever Air Suspension Setup 02
Переглядів 1,1 тис.9 років тому
My Cantilever Air Suspension Setup 02
My Cantilever Air Suspension Setup 01
Переглядів 3,4 тис.9 років тому
My Cantilever Air Suspension Setup 01
John and Brad going off Compression Falls
Переглядів 409 років тому
John and Brad going off Compression Falls
May 8, 2010 Racing Adreyan on his electric 4 wheeler
Переглядів 3611 років тому
May 8, 2010 Racing Adreyan on his electric 4 wheeler
May 8, 2010 Adreyan Riding his little Electric 4 Wheeler
Переглядів 7211 років тому
May 8, 2010 Adreyan Riding his little Electric 4 Wheeler
Eany good videos how to do a oil change on ds 650
Looks like someone took really good care of this quad lol.
Maybe you went to far w/the press and pinched the connecting rod between crankshaft webs which created the stiffness? Find out your specifications and spread out the webs. Good luck.
You have to make a video explaining how do you open tha crankshaft and the size of the bearring pleace
I have the same quad, I just got it back from someone who rebuilt the engine but I don't think he primed it because my oil light stays on. I was riding it yesterday when I got it back, and looked down to realize it wasn't primed. Hopefully it didn't hurt the engine.
😂😂😂😂😂😂
What bearing did you use?
How many ton is the jack?
Red Real 20 ton
Pull the oil filter side cover off, pull the oil filter out of the way, crack the WEEP HOLE cap until you see oil weeping out of it. Then tighten cap and re-install the filter and oil pump cover. You must remove all air from that system.
Why did the fan come on with the key? Was it already hot?
Its not supposed to cut on when I turn the key on?
Bypassed the sensor maybe
What did u replace bearing with I ended up taking crank apart and polishing the bushing and pressed back to together did u find a bearing to replace bushing with
losing prime . I wonder why
Ever figure this problem out man?
There is an oil bleed valve. Remove oil filter and it’s right behind it. Crack it open, crank the engine and it should bleed some oil. Put back together and done. Hope this helps
so did it work out after you installed it?
hey did you end up buying a new bearing and rod for the crank if so which shop been looking everywhere
check the oil pump that may be the issue or something electrical