Відео

Great video!!! Well done, nice presentation. It’s not that I didn’t already know what is going on in a transfer case, but your explanation was first rate, understandable and concise.

Use a 7/32" Roll Pin Punch!

I’m rebuilding my Np205 now. And you answered my question. My idler shaft is hitting my shims when I install it. My question was do I need to shims?? I found out, the answer is yes. Thanks again 👍

Thanks for the great video!

Thanks for the video... I have a question. I am planning to install it on a G-Wagon vehicle(vg150 t/c -> np205 t/c). Is it(np205) possible to exchange the left and right gear assemblies? On the G-Wagon, the rear propeller shaft is located on the right.(not center axle...)

Great video

Thanks for the video. I'm doing a 205 out of a 72 Blazer. What paint did you use? I'm looking at the Dupli-Color Chrysler Red engine paint in a rattle can.

You have to check endplay with the shaft installed in the case with the nut torqued down all the way.

Nice I wood like to know how much this is and I have a 1978 chevy 20 and it got a 454 with a 400 Turbo tranny it got One ton running gears under it. It is sitting on 46 inch tires with a 13 inch lift and a 5 inch body lift I have too many questions to ask. I bought this as a project. I would like to shrink the tires to 44 and put a 205 transfer case I'm still learning a lot I would like to know the best type of transfer case and transmission to put in something like this. That's reliable

Great video. I need to do a flywheel on my 72 Blazer. This should help.

Where did you put the chains at to lift it out? I can't directly tell

And he does it rocking the blue crocks!! 😅😅😅