Відео

same shit every fucking day same shit

The only video I ever found that says brake the bleeder screw! Good job!

BMW N20

This way too much to change out the shifter. Damn

These are not called shocks, they’re called struts. The spring is the shock.

Thank you!

Sept 2024, dealer wants to charge me $2600 to fix oil pan gasket leak on 2017 Highlander.

Whats the tool I will need?

Quick question: what are the torque specs for the bolts? Thanks!

How often should you change your air filters

Good video but if you showed how you fished the alternator in and out would have been more helpful. But over all I feel like I can get it now. Thanks!

How do you check da transmission

Any link of where I can get a Module for my 2009 Escape please?

Bruh gave up the reset

How did you get the spindle off the ball joint, you coventley didn't show that.

Thank you!

Thank you for the video the top driver side I removed the air cleaner helped and then took out the whole bracket. Is that side bolt it come out so that helped also thank you.

What brand pump did you use?

Appreciate the video. Looks a lot less labor intensive than I was expecting.

Where is that 10mm on the left of the compressor?

😂 what happened to the disc 😂😂😂 1:27 😂😂😂

👀👍🏻

Having trouble getting the bolt through tensioner to line up remove alternator grab couple bread ties line up the little block with hole in slide bracket secure in place with bread ties ,now tighten alternator enough so you can line it up withouth having to hold it ,hope this helps someine specially if have big hands ,sucks lol also 12 mm rachet wrench will save shit load time ✌️

Thank you!

12 is pain get

Will come out through the top. Unbolt. Rotate backwards. Will come through the top after removing coolant reservoir hose , brake booster hose , and all electrical connections in the way. Just spent hours trying from the bottom with engine jacked up ,subframe bolts removed with hours of not fitting out the bottom. 10 minutes on top and it came right out.Came right out to the left of master cylinder. DO NOT WAIST HOURS TRYING TO GET IT OUT FROM UNDERNEATH WITHOUT REMOVING THE CAT. Mechanics may not like the truth. But it just happened. Back in after hours of trying to get out in less than 30 mins. 08 cts 3.6 awd direct inject engine. "Performance package" lol. sorry guy in my driveway that spent 7 hours to no avail on bottom. It will come through the top.

You skipped too much important stuff fam & I'm trying to see how to do this

Do you have to mess with the timing chain

My car looks the exact same but I think it’s the line that’s leaking, my car is so low that I bottom out on little bumps

Great job showing how it actually comes out.

I have a 2009, and had to do this today. I found the video awesome. Was able to get it done in 1 hr without touching the exhaust. The hardest part was putting back the heat shield. I do think that 2010+ or awd drive models might be different. So... Your mileage may vary.

THIS IS ONLY HALF A TUTORIAL. YOU DISCONNECTED ALMOST EVERYTHING BEFORE THE VIDEO BAGAN AND EXPECT SOMEONE TO UNDERSTAND THIS. THEIR ARE BEGINNERS HERE WHO HAVE NEVER DONE THIS. LESS THAN 2 MINUTES IS NOT ENOUGH TIME TO SHOW HOW TO REPLACE PLUGS.

WHAT? WIND! WHAT? WIND! SMFH

I’m soo confused why you made this video and didn’t show the audience a thing!!! Bruhhhh a waste of my time 🤦🏽‍♂️

Great video very informative thanks for sharing!

What was the cable connected to where at?

What was the symptoms? Mine does some clicking noises as the relay

Shit video

So this is the supercharged sedan ? Thought the Rs were only 5.0s not 4.2s

Wind NOISE!!!

My Jeep has been starting up funny for a couple weeks. Thought it was my battery, so I got a new one and it was still starting up funny. That was my fault not testing my battery. Went to the woods to walk my dog and it would not start. Figured out it was my starter. Watched your video and went to the part store and got one and put it on right there in the dirt lol. Thank you for this. Cannot describe the joy of a success after such a terrible day.

What kind of transmission is that?

I got p0447 and then I changed the vent valve and now got p0448. What can that be?

Dealership wanted $500 lol thanks buddy

If I am understanding this somewhat disjointed repair journey correctly, you overlooked or didn't read service info on the jumper tubes that extend the rear brake pipes up to the top of the HCU. That black block stays attached to the HCU and the pipe connections up top remain connected when you remove the HCU from the vehicle. There are fittings below the block that you remove, accessible from the LF wheel well. That way you don't need to fight the two rear pre-bent pipes as they pass through and over the HCU bracket.

Just encountred this particular leak, mine was leaking from the front part wher it bends up, it's impressive how badly designed is that pipe, it's steel so it's easily attacked by rust, nearly impossible to find, it will leak inside the V shape over the bloc and between the heads so the coolant will simply "dissapear" into the system, and it can't be replaced unless you tear down the intake system and re-do all the gaskets.

Not sure if anyone will see this message but yesterday my brake pedal kinda locked up almost causing me to crash . It happen as I was driving down a hill, I don’t hear any leak coming from the brake pedal booster and the hose is blowing through it fine when I disconnected and tested with an air compressor. I don’t feel any air or suction coming from the vacuum pump . Could this be my issue?

Great video, very informative. Thank you

Is this the sport model [turbo] ?

Couldn’t see the total video it cuts off .