Відео

Mann du hast mein Leben gerettet bzw. meinen Geldbeutel! ❤

Das hat sehr geholfen. War 1zu1 das Problem nachdem ich den sauger mit luftdruck gereinigt habe. Vielen Dank für dieses Video!!!

What do I do if the LDS runs when it isn’t supposed to? Runs the battery down to 0 in the middle of the night.

Dude, you saved me. Many thanks!

nimm den Kopp weg das nächste mal.

So you replaced that elastic thing around the sensor right? Because it was not good anymore, so in fact before opening the robot, i must have a new elastic to put inside

Mit einem Holz-Stechbeitel, seitlich unter den kleinen Deckel geschoben, lässt er sich Stück für Stück ausklipsen. 'Suche verzweifelt nach dem Ladeproblem, dass er unzuverlässig lädt und nicht immer wieder von der Ladestation abhaut. Ohne zu Laden.

Thank you. I disassemble the robot. The laser unit do not rotate freely when i spin it manually. I opened and cleaned but nothing changed. Do you have any suggestion? :)

Thanks a lot. I can’t believe we solve the problem

Thanks for that. Gave me the confidence to fix the dtof sensor error. Took the cover off saw it was working without it then replaced it. The casing must have been in contact with the spinning laser. All fixed now.

Hello do You have a solution for the anti drop Sensors i tried everything cleaning, unplug battery, even replace battery dosen't Work i don't No what to do anymore.

Vielen Dank! Hat meinen Ozmo 920 gerettet! 👍

Thanks a million - this showed me how to open the cover and get to the sensor. In my case it was simply stuck, something must have gotten to the bearing. Turning it a bit fixed it all. Saved me days of having to send it to the repair centre.

Thx. In my Deebot N8, the sensor cover was covered in dust from inside, that's why the sensor wasn't working. I just cleaned the cover from inside, it helped

Thank you so much! I could fix the problem 👌🏻👌🏻👌🏻

Thank you soo much.. very helpful ... last time when I got this issue, I had waited for a month for the support person to fix this. This time I am able to fix it myself with in few mins.

O kafanı çek 🙁

Grazie a te ho risolto il problema 😍

Many thanks for video. It was very helpfull under dissasambling of laser sensor. Greetings from Poland !

Thanks a lot 👍

So not sure what it is but mine also had that small plastic artifact/debris where the LDS band is. Possible flashing or something not cleaned from the wheel during assembly? Anyways, the top smaller panel is difficult to pop off, but I used a plastic tool (instead of screwdriver) to lift/pop it free from where it was clipped in from the side closer to the middle first, then worked my way around. Didn't break any clips but im sure it would be fine if a couple did break. The other panel must be freed by unscrewing the hinges spring area. Thanks for the video!

Ok guys, you mentioned now often enough it‘s difficult to remove it... but HOW actually do you remove it? How is it attached to the body? Plastic clips which you have to push? Do you need just force? Thanks for the video, the rest seems very straight forward, nice!

Although that's the most moronic way to show the LSD fix, just be aware guys the upper panel doesn't go as easily as he did by hand = you should use a flat screwdriver to gently unplug it from the bottom. Then it's pretty straightforward like in the video

Danke! :)

so usefull for me, thankyou

BS why on earth u show like this? No one can understand how u r doing it?