Відео

do you have a link or model name for the charger you use not the usb c

What’s the difference between the g4 and g5 king tech turbines? Is it true the military scheme mb339 has upgraded landing gear?

Nice plane Jeff. Hey Jeff, I have the MB339 (non-military version 1) MB, and I am looking to upgrading it with buying and installing the gear from the military scheme MB. Is the gear controller box for both Version 1 and Version 2 are the same, that way all I need to do is buy from Horizon the version 2 gear and drop it in. Thanks.

Also what is the minimum battery voltage that you should not fly the airplane? Thanks. Great videos

What is the fully charged battery voltage, to know when you have a full charge.

Can’t thank you enough. I was almost regretting my move from NX10 to IX20SE because I couldn’t figure out how to set up the time remaining. It’s so easy with the NX series.

thank you man.. you solved most of my questions. I wonder not if I wrap up the AR10360T in foam and 3D print a casing for that I f I can uyse that receiver in a jet plane 6kgs and 8kgs thrust which I usually fly and prevent interfeerance.

Hi Jeff I have the New ix 14 spectrum Transmitter. Can I use a spectrum AR 9020 DSM X plus receiver with 2 Satellites.

I don't think so last time I tried it there were some sort of incompatibility issue

Great tutorial! Can this be accomplished between an iX 20 and an iX14 as long as both are updated?

My parent's had that same La-Z-Boy couch. Circa 1995 if I remember right.

Thanks Jeff. It’s the small details that matter .

Or you could just activate the ON THE FLY switch for the elevator.....way more easy.

Just started my build of it yesterday. I wish they sealed the covering better...like some sort of matt sealant.

Great information Jeff. Ill have to get me some!! Thanks!

I could not wait so I got the civilian version. They both look and fly great. Make more MB 339 vids🙏

cannot buy Naptha in California

Thanks for that great tip

When you say, "smaller turbine jets", are you including EDFs or are you strictly referring to "True Turbines"? Just curious.

I’ve watched all of your videos and they have been very helpful. You seem to know a lot about spektrum radios. This is a radio question for turbines. A friend of mine suggested I set the throttle trim so that it acts like a three position switch. So that if shuts down your turbine faster? He uses a different radio system and didn’t know how do do it with spektrum. Thanks for your help

Can you please tell me how can I delete the model on IX transmitter?

Hi Jeff! Would you do a video on the ix20 and the telemetry and any data logging capabilities that can be used with turbines? I’m looking to upgrade from an nx10 and also get into turbine. FrSky and others seem to have data logging and “telemetry” that some say is years ahead of spektrum but I’d prefer to stay with spektrum.

How about making a video showing how to set up telemetry between a Swiwin 80 and a power safe Rx, with a IX20Tx. This seems to be hard to get it to work.

Can you share the link for the USB cable?

What should the battery voltage read when fully charged. Thanks

I don’t have any trouble charging my iX14. I mostly leave it in sleep mode and charge it using a 6’ USB cable. I tried using the magnetic cable that came with it a few times and didn’t like it. My battery seldom goes below 80%. I mostly charge from a USB port on my computer because I use ScrCpy to operate my iX14 thru my computer.

thanks for the video jeff. ive done it wqron g for some time until i found out how by myself and yes i use the same type amazon plug also. my question to you is it ok to leave the radio charge overnight. im afraid of overcharging.

Thanks for the video most of which I was aware of, my issue is that no matter the time it is on charge I have yet to see the battery indicate 100%, indeed whith each consecutive power off and then powering on the indicator shows many differing charge states. Also, I noticed that your battery indicator was varying substantially throughout the video, is this normal with this radio or does it indicate that I have an issue with my Tx, I purchased mine nearly four years ago as well and have always been wary of the battery state?

Great video Jeff as always when Jeff says he’ll be helpful. He means it. He took some time with me at Joe Nall and looked over my Mb339 for me although I still haven’t flown it yet. I take every word that he says as good advice and put it in my artillery of learning skills. Thanks again, Jeff.

A word of warning. Black heat shrink tubing that you use on your antenna has been shown to be somewhat opaque to radio waves compared to clear or other coloured heat shrink as it contains carbon black. It may not block RF completely, but it can reduce it. 🇦🇺

One of these days people are going to wake up and realize the advantages to Electric Power!.. .

For anyone reading this that has this airframe(MB 339) One can absolutely use a bigger size turbine than the K85+. In my case a Jetcat P130 RX. Not that I want to speed and show off, I had the engine to begin with and no plane for it so I tried it and it works. With proper throttle management. The diameter should be under 100mm for sure! and make sure the exhaust fits properly into the bellmouth of the thrust tube. Also keep in mind it's wood/balsa so not exactly the sturdiest and a big engine will rip it apart especially with high G maneuvers and tight turns with high thrust will destroy this MB 339, even though it is 2meter wingspan, it's not that tough. So careful with the throttle when using anything bigger than the K86+ G4. Have fun I certainly am with this awesome airplane, flys and looks great IMHO👍

Will a 100N turbine be ok? As folks say 85N be the max However I already have a 100N engine, so I would like to use it for the Horizon Hobbies MB-339.

Naptha is also called White Gas.

You should also mention that the micro fiber cloths are great for cleaning!

Can you explain to me this question I noticed that no one has made a video explaining about these receivers going bad and if these receivers have some kind of an expiration date because I have two receivers that have all of a sudden stopped working no led light flashes and the thing is they have been working perfectly for over 15 flights now all of a sudden I go to turn my plane on and it stopped working so I plugged up a new receiver and it works fine so I know it’s getting power so why is this happening this is the second receiver I’ve had to go bad in two different planes I’ve googled the problem and no one wants to touch on this subject now I don’t wanta lose my expensive plane while flying can you explain this matter or make a video touching on this subject please

Hey Jeff great video. I am assuming these are JP brakes? I wonder if they sell screws as this is a wear item. I am also sure its rare for someone to actually wear these screws down as most people don't get more than 50 flights on a jet let alone 200 LOL.

Wondering how you wired your chase light?

Great info thanks

Where's Part 1 ?

Another comment, I usually use the ar630, ar631 or the ar8360 all come with asx. This means I don't need to use any of the above gadgets, right?!

Thanks Jeff. Would be nice to make a similar video on head tracker, with demonstration on how to set it up. Thanks

Hello! Wondering if you're interested in reviewing our RZR PRO accessories?

Hello Jeff from Team Horizon. I’ve been flying Jets for several years, using the SPM9574 airspeed sensor. It’s works extremely well, however is now discontinued, due to the supplier, Eagle Tree, now defunct. Can you talk to/convince HH to get a new supplier?, or get with me with contact with the individuals who made this part. The airspeed voice announcement from the radio is extremely valuable for flying turbine jets, especially for landing approach. We very much need this airspeed sensor available again.

My dsm2 11x transmitter binds with my 12120x only reciever just fine Jeff so........?

Thanks for shearing all that valuable information with us!!

Nice job as always, Jeff!!

I did my CG with kitchen scales and good old fashioned math. I was shooting for 5.5" CG and I'll be adding 300 grams tomorrow to the nose good lord. They should have just recommended bigger batteries. I purchased the recommended bats.

Very informative video, thanks for uploading. You have done a great job setting up your Pro R. Any way you could post the details of your Amazon purchases? Just bought a Pro R and I would like to get the same chase lights, LED light bar, turn signal kit with bubble lights, and switch package. Thanks again.

Don't fly turbines, but this was 100% perfection.