- 7
- 47 932
Elanor's Money Saving Tips and Life Hacks
Приєднався 1 лис 2010
#life #lifehacks #hacks #diy #how #how #howto - Life Hacks. DIY. How to do random things and save yourself some money. After careful consideration, I have decided to upload regular videos. I will upload the tips and tricks, and life hacks that I've discovered based on what I've needed and haven't been able to find on UA-cam. Hope to help people with certain things they desperately need but can't find information on and save themselves money that they would otherwise pay someone else to do them. Please subscribe to the channel and like the videos that you find useful.
Sleep Music. 15 Minutes of the Best Sounds To Put You To Sleep Instantly.
This Sleep Music puts me into deep sleep in 5 minutes. Normally I can't fall asleep for hours without it. I wanted to share it with the world to help anyone who needs it. The trick is to have it on high enough that you'll hear it and it will wash out other sounds but low enough not to keep you awake. This takes trial and error. You'll eventually find a balance on the volume. I honestly think this is the Best Sleep Sounds. Enjoy and Good Luck.
Переглядів: 26
Відео
How to measure your ankle for an ankle brace
Переглядів 2,4 тис.3 роки тому
How to measure your ankle to buy the correct size ankle brace. Once you measure your ankle, look at the size guide for the ankle brace you want to buy.
How to remove freezer panel and fix beeping on Fisher and Paykel Fridge E521T
Переглядів 20 тис.3 роки тому
UPDATE: THE BEEPING HAS STOPPED! I couldn't find a UA-cam video on how to take off the back panel inside the freezer section so I read about it and decided to try. I am not a UA-camr but I try to share any tips I can to help other people out so they don't have to spend days looking for something just like I did. WHAT I DID: I used teaspoons as spacers around the edges. I used screw hooks to pul...
How to remove egg off cars... 2 cheap ingredients to remove dried egg without damaging the paint!
Переглядів 23 тис.4 роки тому
Some punks egged my car when it was parked imon the side of the Road and I hadn't needed to go anywhere for a couple of days so it dried up. Took it to the car wash and was told they can't take it off "because when it dries it becomes like concrete". And I know how hard egg becomes when it's dried because in the olden days they used it in mortar to glue rocks together when constructing large bu...
My DIY fix of washing line being too high
Переглядів 1444 роки тому
A before video. Concreted posts to pour concrete as we have a sloping land and I couldn't reach the washing line on the lower end. I will upload a new video of the finished product at the end.
There is like a small plastic thing in top right hand corner? Do you pull it out, turn it or something?
Thank you.
helped. thanks
Awesome vid thank you!
🎉you go Girl ..I’ve got freezer on bottom I’m sure 1 fan not working .. spoons 🥄 I may try this .. gotta love 💕 Women s cleverness
You did real good 👍
You’re a hero
Legend! Exactly what I was looking for. Thank you!
Nice one
Seemed odd using spoons.. I wonder how techs do it.. they don't share info usually. Will try and thank you. Will edit comments if fixed . My fridge may have more issues but the beep started it all.,. Shalom. Can't get my back freezer walk out.. my fridge is a little smaller. . I need more help and feel sick and anxious. Cause of how easy it is for other people... 😭
Hi, from what I saw in the repairer’s manual, they have specially made large hooks that bend the whole panel. The spoons are just doing the same thing 👍🏻
I have the same fridge, but for some some reason its not cooling. Any tips ?
Clean out the ducts as shown. It must be clogged or you might need to order some parts as some repairer videos suggest.
@@TheCitizenKane1 I literally did exactly what you did in the video and it worked 🥰 thank you !!!
Thank you Elanor, our E521T had completely frozen and wasn't draining, there ended up being a block of ice behind that panel on the left hand side, your video help me get the cover off. I used 2 spoons at the top to clear the two clips at the top, then carefully a large screwdriver in the the vents and slowly levered each side off a bit at a time.
My car got eggs by a birds nest that fell 🤦♂️
That’s rough bro 😭 You got egged by nature
YES - This DID help me getting the freezer rear interior panel off and I thank you. I have a slightly smaller model E331T but looks quite similar. This model has a fan built into the back cover so once it comes loose you need to take care not to pull on the connecting wires. First I used some teaspoons as in the video. And then I noticed there are two small holes around the top lip (one on either side of the top edge). I used some small S-hooks I had in my kitchen drawer to hook through & behind those holes which gave me good leverage to pull on the back cover with. So yes, hooks also worked very well for me. Haven't fully diagnosed the issue yet but I've been able to test the 12V fan and had it defrosting overnight in case of ice blockage. I'll now check for other blockages as you had. Otherwise I guess it's probably my temperature sensor gone bad (freezer was fine, just my fridge was almost room temperature). Thanks so much for taking the time.
Turns out there is a second fan accessible from inside the fridge compartment on my model and a wire had come loose from it. Soldered it back on and voila! The fridge lives.
Very helpful, I appreciate your help.
Just got my car egged in -11 Celsius weather...
I have a little silver foil the face plate that was in the freezer ! But have no idea where it’s supposed to be?? It has a small line of old sticky tape but mine wasn’t stuck to anything! Any one know where it goes? Also should the freezer fan constantly run or on timer? Ie: if I plug my f & p fridge freezer E series with freezer on the bottom should the fan work?
Maybe too late to help you, but for anyone else (I was confused about the foil strip as well); I had the same - the foil strip seemed to be sitting loose at the bottom of the coils once I got the cover off. I think it should be taped to the back of the interior cover. There are some plastic protrusions that fit through some slots in the coil so you can see where it goes, and I had old sticky foil-tape marks which showed where it had been attached previously. As for the fan, when I plug my E331 fridge in, the fan comes on when BOTH doors are shut. I don't know if it's on a timer once it's running normally, but this was the situation when first switched on when I was testing mine. To trick the unit into thinking the door is shut, you can move a fridge magnet along the magnetic reed sensor - there's a rectangular cover just underneath each individual compartment (fridge/freezer). The door has a magnet in it which allows the sensor under those covers to detect when the door is closed (by way of that magnet). So you can trick it with a fridge magnet. If you practice with the fridge one first you'll see the interior light come on and off as you move the magnet along that rectangular cover, making it real obvious. Then you can do same with the freezer section and the fan SHOULD come on when you hold the magnet in the right place (make sure fridge door is closed, as it only works with both doors closed).
Looks like I’ll be buying more spoons. 😂
You legend - best tip!
I have the same problem..n thanks to your video hlp mi how to open ta back.but the ice is so tick n hard..to clean .
This was so encouraging, thank you! I'm willing to take gamble after a car wash/detailer said they can't help. Worst case scenario I have to get it repainted anyway!
How did you go?
@@TheCitizenKane1 I'm still putting it off LOL!
Logical👍🏻
адлпалилмаорарараионвлрппвррпооыилм😨
Thank you very much. Your video was very helpful!
Thankyou sooooo much👍
Thank you!
Sorry that happened to you. I tried it out and the oilive oil helped so much. Thanks for the share.
You are so welcome!
Thankyou!! I was yanking at the plastic hoping it wouldn't break. Your spoon trick worked wonders 👍
Thank you again. I used this video months ago to get the panel off and just used it again as I'd forgotten how .. problem solved. Thank you!
Dude... maybe a tub of water to wash all the dirt off, then for a cleaner potatoes 🥔 then wash it under a running tap.. let's save water - think sustainability.
Hey sorry for the late reply. I only had the tap running for the duration of the video. The others I just wet once and scrubbed then washed off the loose dirt. Trust me, I’m a greenie too.
tq dear
Thank you. My fridge alarm started going off on Christmas morning and after removing the ice in the freezer it stopped. But 2 days later a very loud rattling noise started up but trying to remove the back of the freezer to inspect the fan was a very daunting task, as with no screws it looked like a matter of yanking it off and the risk of snapping the plastic was putting me off. But the thought of paying hundreds of dollars to get someone out was worse! Your video gave me the courage to try. I cut two fingers in the process, but I removed the back and chippped out loads of ice and got everything back together again, without breaking anything and the horrendous noise has stopped.
It will work until it ices up again! it h as a defrost problem, its not resolved by just melting the ice away!!
@@maryannsulc-davis2973 of course you are right, but I'm happy to have "fixed" it for now!
@@paragoncumulus6636 Excellent, yes, that is a short term fix to save your food, then you need to get someone to sort the defrost fault. Usually a heater, in a F & P.
thanks very much but i might go by a new one
What a woman ! ! I got the panel off my fridge thanks to your UA-cam. Awesome 💚
Hey 5 years ago you put a comment on a honda civic video - "Hi, I'm in Australia and the yellow plug has four holes instead of two. Any pointers? " Did you ever figured it out? I'm in the same boat
Sorry, just saw this. Nope never got an answer sorry.
Thanks for taking the time to film this tutorial! I did it today successfully to unblock my drain. Again thank you 😊
the problem with using dish washing liquid is that it will strip off the wax, but this is a major help , thanks
You're worried about the non-existent wax, ad she's going at it with a stiff brush!?!?!!!!
Go Girl! you GOT it!!!!
Did it right away. It worked. Thank. Dove soap. Virginia spray. Soft scrub. Hour done! Thank u
You're welcome!
Great video- Nice & easy fix that worked for me -Thanks 😎
thank you 😊 save few hundreds
Thanks for this!
Can I ask what beeping code was it? mine is code 13 thanks!
Oh I don't remember anymore. It's been a while. So sorry.
Mine has defrost issue and it beeped twice so 2 is binary code directly related to defrost according to f & p’s website
hi, mine has the 2 beep issue, I have just pulled the panel off and the drain doesn't seem blocked there didn't seem to be any ice buildup either. fan is also working. just wondering have you had any luck with your issue?
I think there’s a bit of filming that could be improved But this is awesome super helpful
Thank you for this - worked a treat
Brilliant. Many thanks.
thank you!
TIP on removing the back panel: An easier method that worked for me. Using the 2 strong hooks that come attached to the ends of an elastic straps, I passed a hook thru the back panel top left corner and a hook thru the right corner grill, and then gently but firmly pulled the panel out. Caution, there is a fan attached to the back panel in some models.
Fan was noisy n looked for solution on youtube as usual. Found this Excellent tips on opening the back panel with spoon. I also passed a string thru the vent holes to help with pulling out the outer panel. There's another panel with fan behind this outer panel. Watch out for the sensors wire on the right. Mine also had the copper piping glued to the left side of the fan panel. I unknowly bent the piping but luckily did not leak else I can send my fridge to the junk yard. Haha. I had to force the bent pipe back forcefully to fit the panels back in again. Took out 2 big chunks of ice between the back panel n fan panel and fan sound is gone. Hopefully the defroster is working and ice don't built up again.
Thank you for sharing. You're a genius!!