Ben Minderhoud
Ben Minderhoud
  • 9
  • 7 456
De KunstKombinatie
De docenten van de KunstKombinatie in Nieuwegein geven les aan volwassenen. Deze video is opgenomen in de ruimten van de KunstKombinatie in De Kom in Nieuwegein
Переглядів: 20

Відео

Brandon Bay Ireland
Переглядів 4366 років тому
A short travel video of our visit to the Dingle Peninsula of Ireland. Stunning scenery and a little bit of action. Music: Roary - Shy, licensed through musicbed.com
How to flip the boom head on a Severne Enigma wave boom
Переглядів 5 тис.7 років тому
Ever been frustrated rigging a non-Severne sail with a Severne Enigma boom? When downhaul is applied, the boom opening is often to tight to easily fit the boomhead rope through. By flipping the boomhead, you're able to to push the boomclip through the boom opening. Rigging and derigging will go much easier and quicker!
Le Corbier 2017
Переглядів 1187 років тому
Wintersport in Le Corbier februari 2017
Snowboarding Mayrhofen 2016
Переглядів 928 років тому
Wintersport edit snowboarding Mayrhofen, Austria 2016
Imar
Переглядів 1879 років тому
Friend and his son bodyboarding
Strand Horst 9 mei 2015
Переглядів 8669 років тому
Having fun on a short windsurf session @ Strand Horst with Tabou 3S 96l, Neilpryde Combat 5.3, Gopro Hero4
Wakeboarding @ Down Under Cable
Переглядів 2789 років тому
Short session to try out some different angles with the gopro hero 4
Bo
Переглядів 349 років тому
Testing out the Hero4

КОМЕНТАРІ

  • @carstenjudick9857
    @carstenjudick9857 Місяць тому

    Trying to mount a ProLimit head because the old one broke. Now I have no idea how you get to the position of the piece 1:02 (ua-cam.com/video/YN4IK0kWD0Q/v-deo.html). I have the impression even if I would find a way to spread it that much it would break....Thanks for any ideas

    • @bminderh73
      @bminderh73 Місяць тому

      I carefully spread the head with my fingers, being careful not to put too much strain on it. It was quite tight and took a couple of tries, but it did give enough to snap off (and back on). Without breaking.

    • @carstenjudick9857
      @carstenjudick9857 Місяць тому

      @ 🙏🏼! I finally managed by heating the head slightly with a hair dryer

  • @aleksandargeorgiev5540
    @aleksandargeorgiev5540 Рік тому

    When i try to ubscrew the screws, the nut keeps turning in place. The plastic xannot gold the nut. Also there is no room to fit a wrench or a hex key to hold it... How did yoi do this?

    • @bminderh73
      @bminderh73 Рік тому

      I did nothing special, mine didn’t turn, so no idea.

    • @matigimenezlopez
      @matigimenezlopez 11 місяців тому

      I have the same problem. Did you solve it? I think its sea salt

  • @matthewstocks7025
    @matthewstocks7025 2 роки тому

    Its not that hard to flip a sail over before rigging, also yes the extension finishes on the other side but again, its not that hard to thread the ropes from the other side.

  • @montecristo3412
    @montecristo3412 2 роки тому

    to rig a mast rdm, do you use an adapter to the boom?

    • @bminderh73
      @bminderh73 2 роки тому

      Personally I don’t because the boom fits on an rdm perfectly. So that will depend on your boom.

  • @ИгорьКуприн-в6т
    @ИгорьКуприн-в6т 2 роки тому

    Не пойму зачем он последнюю деталь перевернул с петлей для старт шкота. Ее не нужно было трогать. Я так же сделал. Но последнюю деталь не переворачивал..

  • @FreshWaterWindsurfer
    @FreshWaterWindsurfer 3 роки тому

    Awesome video thanks. Is the boomhead supposed to be able to spin around 360 degrees? Mine is new and does, not sure if it's supposed to or something is wrong. Thank you!

    • @bminderh73
      @bminderh73 3 роки тому

      No worries, nothing's wrong. It's supposed to be able to move.

  • @TheAlphahot1
    @TheAlphahot1 3 роки тому

    Thanks for the video, unfortunately I couldn’t untighten the screw on the red part, it keeps turning in place without getting looser...

    • @oadolfss
      @oadolfss 2 роки тому

      Same here, how did you end up loosening the nut?

    • @TheAlphahot1
      @TheAlphahot1 2 роки тому

      @@oadolfss unfortunately I didn’t…

    • @oadolfss
      @oadolfss 2 роки тому

      @@TheAlphahot1 but why not just using the boom upside down, any issues with that? I never did.

    • @TheAlphahot1
      @TheAlphahot1 2 роки тому

      @@oadolfss no because the holes for the clip are going to get filled with water, so the weight of the boom could increase as water keeps getting in

    • @TheAlphahot1
      @TheAlphahot1 2 роки тому

      @@oadolfss the only solution is to rig it as it is, or flip the sail, rig it on the other side, then flip it back and finish trimming the downhaul etc.

  • @Youri_030
    @Youri_030 4 роки тому

    Haha ik mis de tijden 👍😭

  • @jkkoolen
    @jkkoolen 4 роки тому

    Did it as well. I did not rotate the bit with the uphaul rope though.

  • @eileenmccarthy9093
    @eileenmccarthy9093 4 роки тому

    Some is maharees

  • @kylesmart109
    @kylesmart109 5 років тому

    Could you not just flip the sail...??? Just cause a sail comes rolled with the mast sleeve on the right dosent mean you can’t roll the other way so that when you open your sail up out of the bag the mast sleeve is on the left. Solves the problem and dosent void any warranty.

    • @bminderh73
      @bminderh73 5 років тому

      Absolutely! Thing is, some sails kinda keep their form when rolled up one way which can be quite annoying. And, we had to do something due to lack of wind... ;-)

    • @TheAlphahot1
      @TheAlphahot1 3 роки тому

      The problem is the extension too, the ones from severne are reversed