Former Farm Kid
Former Farm Kid
  • 42
  • 39 991
Homemade deer trip alarm has them doing some crazy things.
Our trip alarm has been so successful that it has allowed us to remove our two dimensional fence making it alot easier for equipment access. The remaining fence is for raccoons who were decimating our field. It has been very successful in keeping them out at only 12 inches high. This time around it doubled as a deer reminder that this field is not a great place for them to visit.
Переглядів: 940

Відео

Now the same weedeater/string trimmer won't start! What the hey!
Переглядів 460Місяць тому
This is the same trimmer from the previous vid showing how to tune the engine. One week later I could not even get it started! Figured it had to be something I previously did, but turned out it wasn't. It was a simple issue to fix but not so simple to detect. UPDATE: In fact the fuel lines were correct. The reason for lack of fuel flow was the restriction through the tank line hole. You DO need...
Don't let this happen to your sweet corn! Every plant matters!
Переглядів 399Місяць тому
Sweet corn is one type of vegetable that is good to keep an eye on even BEFORE it emerges! I plant on a time schedule and sometimes have to compromise on field conditions. Usually this works out ok except sometimes, like here, it doesn't. The field was a little too wet when planted and with full sun right after, developed a crust on top. If I had been on top of this, I could have saved a bunch ...
Tuning your weedeater/string trimmer so it doesn't run like crapola !
Переглядів 6803 місяці тому
We give a short tutorial on how to get your trimmer at least running and then go through the steps to get it to run like a Ferrari ! Also, one additional tip: if your engine hesitates when opening the throttle and then catches, open the idle jet screw a quarter of a turn and that should solve that issue.
Adding a flywheel view port on the JD 730D to monitor the taperlock flywheel.
Переглядів 1983 місяці тому
The flywheel cover is not flat so even a center guided bit will want to wander somewhat. Take your time with it and when finished, use a rat tail file to ease the edges to prevent damage to the plug.
Final Rubio Monocoat on Black Walnut Timber base table.
Переглядів 313 місяці тому
Rubio recommends two coats with a sanding in between on Walnut. You will be pleased with the results.
Hope this is last time I deal with a Taperlock flywheel and some installation tips.
Переглядів 1264 місяці тому
Watch to the end to see phone number for assistance.
Mounting the flywheel solo on the JD 730 using a skidsteer.
Переглядів 724 місяці тому
Be sure to mechanically lock the boom in the up position and chain the forks to the boom to prevent any chance of falling due to hydraulic issues.
Taper lock flywheel knocking noise JD720D/730D corrective steps including seals and setting endplay.
Переглядів 2764 місяці тому
Steps in placing flywheel back onto crankshaft. Part 1 shows steps leading up to actual installation which is covered in Part 2.
In circle below, HK = 30 & PM = 8. Find line PR and arc GJ
Переглядів 324 місяці тому
Circle chord work using trig and the Pythagorean Formula. First we check for an ez answer by looking to see if our given triangle might be a 30/60/90 right triangle. It is not, so now we go to trig by using the inverse tangent of our triangle to solve for the angle that makes up the central angle of 1/2 of the larger central angle...piece of cake!!
Shoreline/Cliffs of Dover epoxy resin fill water effect.
Переглядів 894 місяці тому
We showcase an epoxy resin pour with an unsupported edge and what it takes to make sure that it is not going to end up on the floor!
Calculating the pour volume of epoxy resin for an unusual shape.
Переглядів 204 місяці тому
It's helpful to be able to calculate a rough amount of epoxy resin in order to conserve this expensive material.
Troubleshooting the power steering hydraulic pump on the John Deere 730.
Переглядів 1075 місяців тому
It is best to do this procedure with a helper, but I did it here by myself and was able to determine that my power steering pump is A-OK!
Clutch knocking noise on the John Deere 730/720/70 tractor with clutch disengaged.
Переглядів 9195 місяців тому
We replace all the consumable clutch discs to eliminate a knocking noise with clutch disengaged. However, this noise went away engaging the clutch in neutral. These may very well be the original clutch plates or more likely, the second set. Btw, do NOT just replace the outer drive disc but rather, all pressure plates and drive discs...there are 6 consumable plates in total! See our video on the...
Geometric Mean examples
Переглядів 76 місяців тому
Watch our previous video to learn a simple way to set the 3 geometric mean ratios up so you won't miss a single one! Piece of cake!
Calculating the Geometric Mean and the ratios used to do this.
Переглядів 26 місяців тому
Calculating the Geometric Mean and the ratios used to do this.
Repairing the charging port on the Dell XPS 12 Laptop computer by replacing it.
Переглядів 696 місяців тому
Repairing the charging port on the Dell XPS 12 Laptop computer by replacing it.
Little Wonder Honda GX390 powered blower in action
Переглядів 1709 місяців тому
Little Wonder Honda GX390 powered blower in action
Honda GX390 powered Little Wonder blower towed by a JD 335E, zero steer lawnmower.
Переглядів 2339 місяців тому
Honda GX390 powered Little Wonder blower towed by a JD 335E, zero steer lawnmower.
Translation Rule..we show how any translation is based on a series of reflections.
Переглядів 110 місяців тому
Translation Rule..we show how any translation is based on a series of reflections.
Gopher # 33 caught with homemade trap. Watch till the end for release segment
Переглядів 1510 місяців тому
Gopher # 33 caught with homemade trap. Watch till the end for release segment
Tankless water heater descaling flush
Переглядів 3510 місяців тому
Tankless water heater descaling flush
A spherical scoop of ice cream with a diameter of 8cm is in a cone 18 cm tall with a base diameter
Переглядів 8511 місяців тому
A spherical scoop of ice cream with a diameter of 8cm is in a cone 18 cm tall with a base diameter
We show two methods to create the full tetrahedral number sequence.
Переглядів 711 місяців тому
We show two methods to create the full tetrahedral number sequence.
The circumference of the base of a cylinder is x, and the height of the cylinder is x. What
Переглядів 311 місяців тому
The circumference of the base of a cylinder is x, and the height of the cylinder is x. What
Secant segments : write an expression that represents segment "d". Theorem 10-12...For a given pt
Переглядів 2Рік тому
Secant segments : write an expression that represents segment "d". Theorem 10-12...For a given pt
Circle secants; The diagram shows an ice cream cone with a spherical scoop of ice cream on top. The
Переглядів 119Рік тому
Circle secants; The diagram shows an ice cream cone with a spherical scoop of ice cream on top. The
Massive timber framed barn being saved with Galion 150FA Rough Terrain Crane.
Переглядів 25Рік тому
Massive timber framed barn being saved with Galion 150FA Rough Terrain Crane.
Barn coming down
Переглядів 22Рік тому
Barn coming down
Inscribed angles with tangent: the hours on a clock face are 30 degrees apart.
Переглядів 18Рік тому
Inscribed angles with tangent: the hours on a clock face are 30 degrees apart.

КОМЕНТАРІ

  • @user-bn1ov2bi1g
    @user-bn1ov2bi1g 7 днів тому

    Buena tarde

  • @DipaChakma-i7b
    @DipaChakma-i7b 12 днів тому

    How many price

  • @everettwalker9141
    @everettwalker9141 18 днів тому

    Cut up irish spring soap and scatter around perimeter.

  • @billjones5178
    @billjones5178 22 дні тому

    How come u did not run pump for us to see & hear?

    • @lounar482
      @lounar482 22 дні тому

      ua-cam.com/video/Km3DRHl9zRE/v-deo.html,,,check my other video out

  • @HaydenH1997
    @HaydenH1997 Місяць тому

    Your not quite right. The pump would be still be positive pressured if it was from the top to some degree because the pump is lower then the water hight so once it started siphoning it wouldn’t be that much different

    • @lounar482
      @lounar482 Місяць тому

      I would agree, once of course that siphoning had began.

  • @antoniossaketos
    @antoniossaketos 2 місяці тому

    Is it known that the output of the water pump from 1 inch should be converted to one and a half inch 1/2 the input will remain at 1 inch, it is thought that it will work normally without a problem. thanks

  • @garyschmeidler9833
    @garyschmeidler9833 2 місяці тому

    will this pump move water from a tank about 3 feet tall to a grove of trees about 300 ft away with a slight up grade in slope?

    • @lounar482
      @lounar482 2 місяці тому

      Honda specs quote this pump at 120 ft of head. At 120' of total head, it can deliver 1gpm. Since your total head would be far less than that, yes it could move water that far. However, Honda does not include in its specs the gpm rate at that distance. Personally, I would not buy this pump for moving water that far. The laminar and turbulent friction loss through a hose that long will be considerable.

    • @jean-yvesdurocher8467
      @jean-yvesdurocher8467 2 місяці тому

      I got exactly the same set up you have: 300 feet of garden hose with a light slope uphill. I have been watering my garden with this honda pump for 3-4 years. Not a lot of pressure but enough to water my 50 by 50 veggie garden in a short time. Of course: forget about adding a sprinkler.

  • @psdaengr911
    @psdaengr911 3 місяці тому

    Gas Ferraris are old tech. Replace the engine with an electric motor and never worry about tuning again.

  • @KaNapi-uw5fv
    @KaNapi-uw5fv 3 місяці тому

    Info harga

  • @OkoeAnum
    @OkoeAnum 4 місяці тому

    What's the price

  • @OkoeAnum
    @OkoeAnum 4 місяці тому

    The price?

  • @mamadoumoussasow-bc9nx
    @mamadoumoussasow-bc9nx 4 місяці тому

    Salut

  • @khenotida797
    @khenotida797 4 місяці тому

    For its size, is it good or bad?

    • @lounar482
      @lounar482 4 місяці тому

      It's good!

    • @khenotida797
      @khenotida797 4 місяці тому

      @@lounar482 how long for that ibc tank to get full? Can that small gx25 engine withstand everyday use?

  • @derekb6772
    @derekb6772 4 місяці тому

    Cool looking finished product

  • @PrecisionAirsoft
    @PrecisionAirsoft 9 місяців тому

    I really love your setup. I’ve got an older 8 hp little wonder and I like how you too into account how the machine will move compared to the mower. And my zero turn already has a ball on it. I think I’ll try to make a setup like yours

  • @mareppatalavar8093
    @mareppatalavar8093 10 місяців тому

    Cost

    • @lounar482
      @lounar482 10 місяців тому

      $550 plus tax in US dollars...not cheap!

  • @thelaugh24
    @thelaugh24 11 місяців тому

    good

  • @sjohnson9230
    @sjohnson9230 Рік тому

    I just built the same.... Well almost the same.... Setup that you built. Thank you for the video. It really helped.

  • @dolorescorkery
    @dolorescorkery Рік тому

    Promo sm 🎊