- 7
- 334 147
urfanmalik
Приєднався 7 гру 2006
Macaw talks to himself when alone
My scarlet macaw hardly talks around me .... But when alone by himself ... He talks and talks and repeats almost everything I say to him!! It's scary... Lol
Переглядів: 205
Відео
05-09 Mustang Transmission Fluid top off
Переглядів 238 тис.10 років тому
I drained and filled the transmission fluid in my 2007 Mustang V6 4.0L with an automatic tranny.... and this is how I did it.... EASY!!
99-04 mustang Rear Quarter glass replacement
Переглядів 22 тис.10 років тому
I changed the 1/4 glass on my 2002 mustang v6... Coupe!
Solution to a faulty printer!!!
Переглядів 42211 років тому
While working in the garage on my '99 Mustang Cobra... my nephew brought a faulty printer and asked for a solution.... I SHOWED HIM EXACTLY HOW TO DEAL WITH IT!
Lincoln Navigator fuel filter replacement for 05-06
Переглядів 73 тис.12 років тому
Location and replacement of fuel filter. It is not the same as 03-04. Make sure to first turn off the air suspension system with the button in the back lift gate in a compartment on the left side. Then take out the number 12 fuse for the fuel pump, and start the vehicle until it turns off and repeat if necessary, to finish the remainder fuel in the lines. After that remove the gas cap to reliev...
Bathroom Boogie!! Ali's Own... :)
Переглядів 27513 років тому
Ali showing his dada all the dance moves he knows!! While everyone is sleeping, he just had to do it.. Lol
Good job
Me too!
I hope you didn't break the glass again by just shutting the door you never reuse the sealant you are supposed clean both the window and car and apply new Urethane Glue and let it sit for 24 hour but ribbon sealant
Will burnt fluid cause my transmission to jump out of gear? Does not slip..goes to neutral
Cool video. But it would have be great and informative to tell folks the size of the hose you used
Lol
Exactly what I was looking for
Wow such an amazing video, thank you for this
Not supposed to drain all the fluid and replace with all new. Going to break his trans
That's some of Ford's better ideals Now does the car gotta be level or can just have the front end jacked up when you're checking the fluid
Is there a dipstick under the hood? Or only from undeeneath
Freaking awesome information very informative thanks for the heads-up and 🙏
Hey friend. I'm topping my transmission off but when I take the pump off and let the fluid come out it just doesn't stop. Am I adding enough liquid? Does the car need to be on for it to stop on its own?
if you remove the oil pan how many quart do you need please share pump type and hose fit size if possible my trans after changed oil get an issue with gearing in D & R no acceleration very low does that mean oil is low or TCM unit issue or could be solenoid pack case
Thank you for a simple CLEAR explaination and how- to. I'm happy to know NOW that all I need is more fluid and not something unfixable.
Should have changed the trans filter and cleaned the inside of pan & magnetic washer. Use the original pan gasket and buy a new trans filter for $20-$23..
Thanks a new one on me lot of information
2005 fill trans
What size is that drain plug
T 30
7/8 inch
What size is that drain plug ???
7/8
Forbidden Gatorade
Useless video. Why didn't you just tell us what size the tubing is? That's the only thing anyone needs to know about this procedure.
Good stuff!
Will it be the same for a GT?
Anyone know the size of the tube used to fill?? I’m not changing the fluid just want to add or I’d take the plug in to the hardware store. Someone has to know??
Did you ever find the best size of tube to refill it ?
gracias por el aporte
Thank you. YOu did a good job on showing the removal of one of these. Just what I needed to see. Glass guy said 40 bolts would have to be removed and it would cost $125. He said he charged car dealers $250. What kind of guy does that? LOL I got my used glass off of ebay for 28 bucks and 8 shipping. I will do this myself since I'm a car restoration guy I won't have any issues.
Ford never ceases to amaze me in completely backward thinking ways to design systems...….. what a stupid way to check or fill a transmission. Hey ford engineer your an idiot
Wow I just saw a magic show there was the old one and boom the new one just appeared with out showing how to remove clips, what is your next trick?
Whoa! You did way too much, all you had to remove was the inside window panel where the seat belt and hanger is, and the sail panel on the outside, overworking is how you lose parts, that's why I'm stuck with a damn leak because the guy who painted my car left something out on my quarter glass
Hey Howard so far this the best video I found but if you can make one on how it's done please post thank you
How do you remove the sail panel without breaking it?
@@aro5276 there's 4or 5 bolts on the inside that'll loosen it.
Shocked you fill from the bottom and you have to guess at the level! Ford this is a terrible design. No dipstick either.. why not a fill plug up on side?
The fill point of full is not a guess, this method is called stand pipe method where the plug is a pipe that stands up to above the fluid in the pan just to the point that with the torex plug removed just drips not runs out when full. If it is running out it is over full and when it stops totally the fluid level is full. The car has to be running so that the syntrivical force of the torque converter keeps the converter filled to max running level and the remainder of proper level is in pan. Turning car off while torex plug is out will cause half the fluid in torque converter to drain out of pan through stand pipe torex plug leaving the transmission a few quarts low. Not having a regular dipstick was done to seal the transmission from possible contamination through dipstick tube and was meant to last 100,000 plus miles under normal use or at least that was the engineering design thought when it was designed. This also makes DIYers leass likely to do servicing their transmissions far less likely and a high dollar shop profit for the dealers.
@@LisaMB2forU Way to go, Ford... Take what should be a simple procedure and make it as complicated and ridiculous as possible !!! ...FFS >:/
I have a 05 mustang gt manual transmission and it’s leaking from one of the lines. So how do I know how much transmission fluid t put...
Where did ya get the clear tube from??
this might sound like a dumb question but does this trans have a pump that circulates the trans oil???
Thanks dude, This helped me save $288 dollars to have ford to do it
They want $406 now the scam artists.
Cant this be done on the 2010 4.0 too ?? I mean its the same right
CenCal Stang yea 2005~2010 they're all the same basically.
Can I add Lucas transmission oil
I have a hard shift on second gear can I add Lucas transmission oil
Could i just hit the intertia switch instead of removing the fuse?
Video very helpfull
Great video thanks
use a t-50 torxe
Hello there, I have the same model as yours. I m trying to change cabin air filter. I didn't find that under dashboard. Can you pls tell me where is this located? Thanks
Thanks for the video, it really helped out. And yes, I love Mustangs too. #MuscleCarsAreTheShit
I have a question because I have a Ford mustang v6 4.0 2007 and my question is where's the oil dipstick transmission locate at ? If you can please let me know
Giovanni Barajas doesn’t have one bro :(
So I was doing this to my 09 mustang and when I was pumping the transmission fluid it started to leak when u pumped it in. Did u have the same problem?
By the way I have a 09 V6 automatic Transmission
Bery helpful video. Question: do the trim pieces under the glass simply pry up and out or is there another procedure to remove them?
Family Dameron they just simply pry out or pull out ... it's simple but have to be pushed in, in a proper way ...
thank you for that man it did help a lot with my mustang
is this a manual transmission
thank you, my friend just bought a 2003 mustang but the rest right window was broken. Other than that, clean vehicle