Відео

To have autohold function triggered again, Hikoki needs to be disconnected from the input or the input value needs to change to another range. Otherwise nothing happens except the bargraph movement. Fluke autohold is differently implemented and I prefer it. This is valid through all modes, not only in resistance. Hikoki manual says: "when the test leads are moved away from the measurement objec...

Disclaimer I am not paid by Bosch company for marketing their products, nor paid by Bosch's competitors to show the issues of Bosch tools. I bought these tools with my own money and did this small experiment to satisfy my curiosity. I had a surprise and I wish to share it with you. Watch the video till the end. Any questions/observations/ideas are welcome in the comment section. Additional note...

@GuedeService Informations from manual not shown in the video: - max torque 25Nm - chuck capacity min 0.8mm, max 10mm I am not a professional videoblogger/youtuber. I filmed this with my cheap phone. This video was made with the purpose of sharing some info, not for marketing or money earning. Questions, suggestions or ideas are welcome in the comment section. 🇹🇩

I am not a professional youtuber and I do not gain any money from this upload. This is not made for marketing purposes for any of the two brands. This video is just a simple experiment. Questions, ideas and observations are welcomed in the comment section.

Drill battery comparison Hyundai vs Raider (both 20V 4Ah rated)

@hyundaipowerproducts

Sorry, but I am not a professional video blogger. This video is not intended as marketing or personal money earnings. It is only for your info or help.

Video response for topic "Owon bench multimeter?" from eevblog forum.

When you feed the multimeter a 50% pwm square wave with offset greater than the amplitude, if you go to mV scale and switch from DC to AC several times, the second time on AC it will measure 0 mV. If the signal has the offset less than the amplitude (for example 0.2V as shown in video), you won't get this weird behavior. More about this dmm here: www.eevblog.com/forum/testgear/ut139e-and-ut139s...

I say it's poor not only because it misses sometimes, but also the beep is not continuous when it should be and then when the probes get disconnected, it will still beep for another half second or so. Overall is still a great meter with nice accuracy and plenty of useful features for electronics use. And the display looks very cool. More about this dmm you can read here: www.eevblog.com/forum/t...

I found this behaviour while I was doing some tests with my dc load in series with this dmm. Notice how on DCV scale it does not happen. The relay inside just clicks once and it's all good. I also tried different values of voltage and current, but this happens only between 200mA and 2A scale when set to autoranging. Read more about this dmm here: www.eevblog.com/forum/testgear/owon-bench-multim...

...

It is jumpy because both multimeters were plugged directly into a power supply (Aim-TTi CPX400DP).

interpret: Ghiorghita Axinte