Відео

Are there interchangeable batteries ? My screen is blank

I've been trying to get my thermostat upgraded for over 5 years now. When I call trane customer service, they tell me to contact a local dealer. Well, to date I have called 13. They either say they do not know what I'm talking about, or they want to send out a serviceman to look at the unit. (Why?) When I bought the system it could be updated via the internet, but not anymore. My zoning system has been a great disappointment. When I turn off a zone, I have learned that they are programed to allow 40% bypass air to the zone that is turned off. So, I cannot turn off a zone. I will never buy a Trane system again. Too expensive, poor performance.

What is amazing is that none of the dealers I have contacted know how to up grade the firmware for this controller. It use to be on line, but now a dealer has to do it, but they don't know how. Probably applies to the new 1090 controller also. Not happy with my Trane. Poor manufacturing had coil supply lines rubbing together thast caused a failure after 10 years. Out of warranty

Why does it allow 40% bypass air for "closed" zones? When I turn my zone off, air continues to come thru the vent?

I can smell the mildew and growth through this video

Are those coils and expansion valve guaranteed for life? Where is the drain for the coil? With a positive system does air leak out?

Virtually unheard of to not have a leak in that pos coil. The only time its not the coil is when the evc board fails or both the temp sensors fail and the system pumps down. As a trane comfort specialist we dont install them anymore cause they are high priced junk. Trane has solved 0 problems on these units.

Note the best evaporater coil is copper . Aluminum is very difficult to repair.8/7/2022yr

Would you install the trane effect and the Honeywell filter together

I just had a clean effect installed do you recommend me removing the low budget filters in the returns

Do the "clean filter" lights on the front even work? I've seen 3 videos now that have dirty filters and the front panel is showing only a green light. We have a customer that keeps calling us about this because the light never changes.

So this thermostat will control multiple trane systems? or do all zones have to be on the same system?

Just not built like they used to be, that EEV is a mother

You told a fib on the first time you removed the doors. You said "as you can see the door are extremely easy" to remove? NEVER! Once they are installed and the refrigerant lines are attached and the thick ass 1" insulation is covering the lines, especially on commercial units, the doors are extremely difficult to remove and tares up the insulation and almost always hard to lift up due not only the refrigerant lines, but the condensate drains and SS2 switches are in the way. Try to remove one under a house laying in water too! You engineers don't tell the whole truth, just half truths! AND the screws fall out of the clips and the plastic washers disappear and sometimes the clips fall off and now the door is taped on.

junk

Just had a TAM9 installed last month. Here's a warning to anybody wanting a TAM unit. They are noisy if the return vent is directly under the unit. The unit is in my garage on a box that opens on the other side of a wall into the hall for grill. There is constant, high pitch whine from the fan motor that sounds like you're in a jet at cruising altitude. Putting the fan motor under the coil has to be one of the dumbest ideas. There is nothing to diffuse the motor sound. They installed a baffle in the return but it didn't help much. It's a beautiful unit that works well but had I been more informed about the TAM unit instead of listening to the salesman who said it wouldn't be noisy being the unit was in the garage I would have gone with the TEM unit instead.

Was wondering why I cannot get a coffee stir straw at McD's anymore. Trane has been using them to make their cells.

Why bother to use Trane? Their evap coils are junk.

Junk

I’m going to correct you you don’t have to remove the refrigerant you can recover it in the system then when you’re done your release it back you just make an advertise for your garbage units

Yeah, until that trash plugs up a feeder tube feeding a set of passes in that coil!

Too loud

If you properly flush and vacuum your lines on install, there should never be any TRASH in the system, unless of course the unit came off the manufacturing line without being flushed. The only reason Trane put a self adjusting metering valve in is because there is no tech in their right mind that's going to touch an aluminium weld in the field. I really wish Trane would make a unit after a panel review by real field tech's.

I currently have an XL850, to upgrade to XL1050 can I just swap it or does it need new wiring?

Trane sucks buddy Trane sucks people don't buy train they fucking suck.....

I can’t get mine to control humidity for anything. Set it at 45, house is at 60

Not only show, but also dis-play pictures on your wall?! Incredible!

he explained it wrong the section after the Prefilter has a Positive charge and the 3rd Section is Negatively Charge and attracts the Positive Particles....

This unit is a piece of shit the aluminum can't handle the pressure bye copper coils

Soooooooooo not worth the money....

Wow neat. Looking at getting an xv18 with this thermostat.

I think my door to the coil area has warped. Leaks air on both sides - had to use duct tape to seal. Is this a problem on all the plastic air handlers or just the TAM8?

I have one and it no longer stores the runtime data or service timing (humidifier pad, service date etc timing) when we have a power outage. Is there a changeable battery in there or did they change the software to not allow data saving?

In reality, the Clean Effects / Accuclean are quite restrictive, check it with your manometer. Trane’s claim of “low restrictions” is NOT accurate.

Asking for a friend.

We know you are getting paid by trane we dont need to see your face but the tstat. Bad video sorry

Oh boy I'm going nuts in my shop trying to get this AC system to work and every number I call and trying to get trane support they will give me the run around :-( I'm definitely will research other brands for my future home replacement

The camera man is horrible. I don't need to see the person talking, but I do need to see the thermostat! The constant zooming in and out is very annoying, too. Use a tripod.

If the coils get dirty and the condensate doesn't make it to the drain pan, how is that going to work with the blower on bottom?

In the case of the Trane heat pumps sold extensively beginning in 2005, many found the unit stopped because of a defective coil. Tranewreck.

I have heard the Hyperion Air Handler can leak -- and Trane allows up to 2% leakage -- what is Jackson Heating and Air opinion on the leakage issue ?

Next time clean up the job site. and the wires look like a nest

Dale love the videos. I am trying to make a decision between a 3-ton xv18 and xv20i could you do a video on those and the benefits of each? Also can the xv's be oversized by a ton safely or should they be right sized like other hvac's?

I have had these thermostats for about a year, and cannot get them to reliably communicate with each other over my wireless network. Neither Trane nor the installer has been able to solve the problem. The latest information I have gotten from the equipment distributor is that, although Trane says the thermostats will communicate with each other, they really don't, and they have no solution to make them talk to each other.

Great video.. Our company installs a lot of these. I now understand why the label that reads, "A small amount of air leaving the air handler means it working as designed" or something like that.. Our county inspectors here in NC will fail our installs if they feel any air leaving the doors. They all have to be sealed. Can you foresee any issues with that in the future?

2440 sq ft house 2x6 stud walls double pane windows and 5 ft attic insulation and insulated floors in Virginia near NC border .I do not want over kill on a unit when I may sell in a year or 2

what size is that unit .I am thinking of trane heat pump 4 ton and they want to put it in with hyperion xl or can this go with hyperion xr.outside unit xl18i

Nice job dude!

Awesome! I have a seven year old Trane single stage heat pump system with a variable speed air handler. I would love to upgrade to communicating technology with modulating zone dampers. How much difference do you think it will make on a single stage system? Will I need a barometric bypass or will the blower be able to ramp down enough (via the bk terminal) to lower static pressure? Thanks:)

Why did you not show the other 50% of the unit, the air-handler ?