Відео

I left my gas cap off the car by accident. Drove about 7 miles before realizing and I just happened to look and my light is on. Hope this works

Question, I have been screaming for a year out house has mold and nobody would listen and I’m so highly allergic to it it busts my skin open, I stopped breathing at one point, all kinds of stuff. I have a beautiful incolay jewelry box given to me by Client and I’m wondering how to get the spores off it Without damaging it.

I love how careful and precise you are when you work. I didn't know changing a cord could be that simple! Well done!

2011 vw scirocco, 2.0tsi. I tried the launch control with the DSG box and now check engine light is on. Please help 🙏

Every time when I filled up my car, in the third days, engine light came on, and back off, keep going back and off, I very frustrated!

I washed my truck & car's gas cap in a pan of hot water with dish soap. Rinsed it well with hot water. Let it set for 24 hours on paper towels to dry. Coated the rubber seal with Vaseline before installing. It has been a month now & it works like new. Reply

Great video! Made replacing the damper very straightforward. I would just suggest turning the fridge off before doing this, as the wires to the damper motor are 120V.

1. Lay a throw away blanket or some wood under pipe to make a little less painful to get through, 2) wear mask under house so you don't breathe particulate matter - all that stuff you can see in front of flashlight

Foundation repair is a bit misleading, this house has no foundation. It was literally build on few concrete slabs

I have two beautiful boxes that were heavily smoked damaged. How can I clean it?

That is the filter, but there is a deodorizer cartridge somewhere on it. Probably on the back of the seat, remove the seat from the toilet to find it.

That seems like a huge span where you started working. Could be a great reason for movement and sagging, not enough structural support. You must be in a nice climate to have open pipes and no insulation in the floor. Appreciate the video - going to be jacking up half my new (old) house in the spring to level flooring but its wet, cold, and much nastier looking than your nice dry space. Yeah, me.

Do big box stores rent out Bottle jacks I don’t feel like buying 6 jacks.

I bought a new chain. $6 why bother sharpening the old one?

We bought a cabin that had this done 4 years prior, they did a great job BUT in 4yr it already is sagging again. Is it proper to remove the floor boards to allow for digging a proper full depth frost line footing?? The amount of sag on that particular site, would mean we would be adjusting it ALL the time and we dont want to be dealing with that...

This is AWESOME!! Thank you! You may want to update this tutorial as some of the settings you mention are indeed the same but have changed locations on UA-cam. However, the steps still work after I found each setting. This has SAVED ME SO MUCH TIME!! Thanks again!

It should be illeagle to have crawlspaces less than 5 feet deep.

Greetings 😊- wondering if you can assist please? Is it possible to copy someone ELSE'S playlist and put on my channel?

I just bought an old farmhouse I've lived in for 24 years. The foundation is made from some kind of home made concrete. There are small sea shells in it. There is no crawlspace. Which means tearing up all the flooring. Each room sits on a foundation. This means I have to tear up each room to gain access. This house was supposedly built in the 50's but think it's much older considering there's a blocked off chimney in the living room and in the kitchen. The original fusebox took 4 round glass type fuses. Good insights here on what to look for. Definitely going to need adjustable brackets you mentioned.

I have a 2011 cruze lt. I want to ask something regarding the gas cap. In my car, the gas cap is with key but i didn't get the key from where i purchased my used cruze. So the gas cap is without key and it doesn't lock there properly, click sound comes, but it still remains loose, even with click sound i can just lift off the gas cap it will open, it never tights. Maybe because i don't have its key?? Also in my car, engine check light is appearing, it's not blinking though. I think that due to this gas cap, the engine check light is appearing maybe. Also my car is burning a lot of fuel, the crazy thing is when i leave car at park in the night and again go back in the morning the fuel shows 1-2 needle less on the meter as compared to when i checked at night. Why is this happening and what should I do?? Thanks.

thanks for your time and effort preparing the video. its very helpful. Not a project I'm looking forward to but I gotta get er done.

Thanks Coach

Thank you for a informative and calming video on the check engine light I’m over here freaking 😫out LOL

After looking everywhere for a video where the housing is removed and cleaned, I found you. I own the exact same Remington 3.25 HP, 16”/41cm electric chain saw. Lucked into it for $12 at my local pawn shop. Feel like I stole it!! These things are mighty work horses for the suburban jungle and up keep of smaller rural plots. Thank you for being thorough enough to actually show a properly tensioned chain as well as removal and cleaning of the oil reservoir. My cap doesn’t have a bulb but the whole cap and neck depress so I assume that is the pumping action. Mine also has no spring clip on the drive shaft guard, it’s an actual screw. I have no idea if that means mine is newer or older, but hope I can find a manual for it soon. In the meantime, it’s cleaned, has a new chain properly tensioned, and oil in the reservoir ready for action. I have four nuisance trees to get rid of before they wreck my wooden fence. Cleaning and a new chain were step one. Wish me luck with the rest!

Ground sunk because water issue,or some reason, but you need cement footers which should be 16"x 16"x 8" deep cement poured in ,cement foundation block set and leveled on wet cement, after cement dries stack foundation blocks or 4" or 2" blocks then shims. You do not use wood post close to ground possible termite problems. This by most inspection codes in case you ever sell the house and have an inspection. his way will work temporary

Question: When I was tightening the grommets, the top part of the rubber grommet sort of popped out. It feels like the screws will never tighten. And the seat moves a little bit. If I tighten them more will I break something?

Thanks for the detail that was left out of the official Toto site instructions!!

I got a quote today, they want over $100k to "stabilize" the wall, plus 20k engineering fee, and 5% permit fee. No thank you I'm doing it myself, excellent help sir thank you.

thanks bro exact fan i was working with

What about for newer model that no longer have a gas cap?

Adorable. You saved these two cuties from the landfill, thank you for your service.

The EPA thought of everything!

Could this stop your car from moving.? I'm currently stuck. I share the same situation. I went to the gas station earlier today and i went out to run an errand and the car was stuttering upon acceleration. I immediately stopped the car and turned off the engine. Happened shortly after i started the car again, then boom, my car is parked 3 blocks from where i live and it won't move at all now. I have a 2014 nissan rogue select and i have no idea how to diagnose this. Please help P.s: i did the steps you laid out to no avail

Talk about sweat equity AND construction know how! I'm so blown away by this project and the beautiful repairing you and Brandon did!

Did you have that outlet installed? I don't think that's normal.

Can you still find TSP? In Arkansas all I can find is the TSP substitute. I'm not impressed by the substitute. Great video.

Same thing happened with me today 😮😮 I just left the fuel station and engine light popup and my car was running good

"cap washing cage" is what its called

That was a great and simple job. Thanks!

After I tighten the two metal screws, the rubber grommets would come up a notch. I can't get the screws to tighten completely regardless how hard I push down. The brackets shakes a bit. What am I doing wrong ?

Spunj

Beef up the security of your gas tank if you're going to replace your gas cap. Purchase a lock n key gas cap. You never know when you may be some random victim of idiots trying to pour something down the gas tank of random cars. It happens

I was scared to death to reshape my fedora. Thank you so much for showing how easy it can be done!

.

Always buy Japan ( TOTO) brand when it comes to electronics or devices. They’re always 100% durable reliable. Japan cars also! ❤

Why remove the inlet valve?

Thanks for posting! This was a great video with simple instructions. I know I need to repaint the porch of my 100+ year old house, but it's intimidating! Can you tell me what that cute little scraper is that you used? We have many boards by the front stairs that need some attention. (They're definitely cupped, but I'm hoping they don't need to be replaced and can do with a simple scrape/filler/prime.) Can you also confirm that the DAP Acrylic Latex Caulk is paintable? Again, thanks so much!

It looks as if the structure is being supported solely by the perimeter footing. That tells me that the builder did a piss poor job of compacting the site prior to framing.

thanks. identifying parts is greatly appreciated

Thank you! Super helpful!