Відео

Mine does the same and but doesn’t over heat. Also after drive for a while it goes back to normal all my fluids are good any suggestions??

IPAAYOS NYO PO SA ELECTRONIC SERVICE IPAPA PALIT NYO YUNG CELLS O IPA BLOWER NYO YUNG CHIPS AAYOS PO YAN KATULAD SAKIN

Your video help. Their hoses in the back of the plenum 2 on each side. There is also a clip you need to remove on the passenger side. 10mm bolt holds the oxygen sensor. Do both damper, myb15 Qx60 is really quiet now the noise is gone! 🙏

Pathfinders are trash never again.

Timing is screwed up!

Excellent!!! Start with the simple possibilities first!!!

thanks for the video

Good one

Great video and tips..

Thanks man. After you said you tapped the top, i just poked the screen and it fixed itself

That air ratchet is a little Overkill 😵

Maybe the tube's of the radiator are older and when you press gasoline they swallow and close the pass of coolant. Need to change the tube.

This happened to me this morning on my way to work. The C and H completely disappeared and then came back on but then started to overheat. Will look into replacing the cluster..

Fixed my nissan pathfinder 2014 thanku for ur help and video ❤️❤️

Aaa

What did the Aspen have that it did no turn on ?

I love you, thanks for making the video

Do you have to take the valve cover off to reach the back damper? I saw a video where a guy left it on, but he only changed the front one.

Does the engine light come on if the fuel regulator/damper is bad or going bad? Cause my infiniti qx60 does this exact noise but no engine light or Codes given

2009 Camry got codes poo31 and poo51. It says I need Low Bank 1 sensor 1 and Low Bank 2 sensor 1. So after some research heres what I found. Check how many o2 sensors your vehicles actually has. There's two UPSTREAM an two DOWNSTREAM. Toyota recommends you replace both at the same time. Now when I had the computer at the auto parts store run it said Heater Oxygen Sensor Heater Control Circuit Low Bank 1 sensor 1 (poo31) and Heater Oxygen Sensor Heater Control Circuit Low Bank 1 sensor 2. LOW BANK means UPSTREAM. The guy at the auto parts store said if its downstream it will just say something like BANK SENSOR or something like that. Anyway, so of course I started checking online for parts lol they werent priced bad at all. Then I start reading reviews and people are like "Don't buy this junk" etc etc. Apparently, you only want to buy genuine Toyota sensors. DENSO makes Toyota sensors. DENSO is what i can buy at my local parts store. The guy at the store started laughing because i ran over to return one I had already bought and hes like "Look it up Toyota owns Denso" lol its the truth lol anyway, I bought the two sensors but my mechanic keeps saying try the relay so i guess we will. I know my check engine light is on and my car is getting hot too quick. Its not going over half but its faster than it should. I let yall know what happens hope this helps anyone looking for info

Thank you, Found AF Fuse Missing! 10A Fuse was slotted into the Blank Spare slot and the AF Slot open. Masive waste of my time. Now solved thanks to your video.

No way i just changed the belt on mine and its doing this

Where's the best place to order good quality parts from?

So you didn’t have to solder it in? I have the same issue takes like 7-10 minutes to prime

What can cause it to get gas just not firing

Did the light comeback

The autozone replacement part# CSC1076 worked perfectly on my 2008 Honda Civic. It was a I5 minute repair thanks to your video.

Very helpful video, wasn't what I was looking for but showed me what was involved with accessing the rear of the engine for fuel injector replacements, none others so far have.

Just ordered the parts needed, hopefully this fixes the annoying cabin sound. Literally sounds like the suv has a small cam 😂 Thanks for the video!

Is it safe to drive long distant with my car like this

Thank you, thank you..

Part # ?

Thanks wifes truck is making the exact same noise in a JX35. Been looking everywhere for a cause.

Did you car start intermittently before the repair? My honda starts 95% of the time but maybe once a week ill have to sit there and turn the key over over and if i turn it slow i do hear the buzzing relay noise. It eventually starts though. Changed the starter already. Only reason i think it may not be the problem is when it doesnt start the remote starter wont work either. You would think if it was ignition switch related the remote start would aleast work right or no? 🤔

Did you applied the honda bond thing all around or just like the corners??

Fixed my Infiniti qx60 today. Thanks or the video.

ua-cam.com/video/OhiJa1N-gxo/v-deo.htmlsi=dODmlf02WrQ8-oGG

Mine goes up past halfway but doesn't overheat.any suggestions

Where are you located? I just had the similar problem..and just does the same when I try to start it ,please let m know what you said the problem was so I can find a mechanic..to help me..here where I live.single mom..with kids..

How did you diagnose this to know what was wrong?

Really good video - thank you for making it!

I got a bunch of sensors that just started to fail for no reason. Maybe i have bad fuses ?!?

seems there are 2 gas rails? each with a few dampers? you replaced 2 dampers? i thought 1 rail had 2, and another rail had 1, and the PCV model number is for pathfinder 2002-2004 ONLY, i thought your truck was a 2015

That’s my video. My truck. You used. I haven’t fixed it yet. Watching your video now. :-). Are you a mechanic. ??? I’m not brave enough to attempt this.

what year is this frontier ?

MVP

its the fuel pump

I have a Circuit high you have a circuit low is the problem the same? 2008 Prius

Thanks!

Thanks!