Відео

I think just a cover up attachment. Works so good!

No we cut the end going to our pump and fed the wire through. We used a junction at the basin and made water tight connections. We use pump wire in bulk sized for each job. This outdoor cord was rated for the amps needed and length from source and we went this route only to keep it within the clients budget. Another water tight enclosure at plug behind AC unit. You want to make sure you have these pumps tied to a circuit all their own, As stated in instructions on a lot of pumps Ive seen. They will trip breakers if not sized correctly or trip overload outlets that control other appliances on the circuit.

Appreciate the information. We don't do much drain work but this may make it easier than using the larger round containers.

Yes u can use a standard size drain box 12x12 in this case just depends how much water your dealing with. Check valve in separate box no problem. Mounts vertical or horizontal in this case. Getting into 18 basins are pricing but needed in some applications. Using a smaller basin you have to adjust the pump depending on the water your dealing with to keep it from cycling on and off too much. We pretty much use a pump basin in all applications. This case there was a challenge to have one installed due to concrete slab left below grade. There was enough volume between basins and pipe to allow pump to cycle correctly.

I want to say 4-5k but we had to Bore under drive with that added cost . We use larger pump basins now but this was a complete up hill battle with water but it is still going strong. I can check if I know someone in your area. I’ll be in touch and thanks for watching

Pump hasn't been removed in that whole time. Some still going about 6 years before really having to remove. We never use flex hose in a pump install. We will put a quick connect coupler on the discharge line in the basin for pump removal. We may not have stuck one on here, but it would be installed if we had to cut the discharge pipe. Not hard to cut PVC. The way we design the system the catch basins "catch" most debris before hitting the pump pit where the pump is. This actually is a large catch basin which I don't like to do since it doesn't have volume of water, but this situation the water level in the yard keeps the pump going long runs. But no not hard to make a cut on the PVC discharge if needed, then install quick coupler.

Yes!

They seem to work both ways. Haven't had issues mounted either way. Larger basins we will mount vertical. Smaller ones like this job we did horizontal enclosed in its own valve box.

Sorry it’s actually a 457 liberty aluminum 1/2 hp

I dunno been doing them same way for 10 plus years same pumps going.....

This is a smaller basin but the minimum the pump requires. Usually use a pump pit. Have to see why we didn't here there was a reason, its been 4 years or more and pump still going. But yes we use pump pits 99% of the time. This corner of yard sees a lot of water.

This is an 18x18 NDS drain basin. Site One, Ewing Irrigation, or maybe even Lowes or Home Depot will have it.

Dont know how we have been so lucky for 20 plus years doing this type work...???

Thank you Amy. No lack of knowledge here. We get it done. Thank You again!

We always come back and touch up ;)

We try to be as thorough as possible each job. Thank You for your comment

Nobody practices that here in this part of Texas. Maybe the clay ?? Not sure