Відео

Peugeot suck putting the oil filter in such a crap position. I'm planning on doing this oil change, but only have a 27mm short ring spanner. Thanks for sharing your video

Thanks for the solution 😊 I came upon your video searching for a way to fix the connector, but I will now rewire the ground.

Absolute legend

Do you still have this?

Very useful video. Did you have to remove the front wheel and wheel arch trim to get access to the bottom?

Can you just change a bad cam on a xud9 while it's still in vehicle

Thanks!! Same issue here too... Once again thanks for your help. This is Bijo from India. 🙏

Good video mate

Thank you ❤❤❤❤❤

the clip won't come off

Thanks so much, my car had the exact same problem. Keep up the good work!!

Quickly question, there's a small retaining clip that comes with new pads which I think fits on the inside pad but I'm unsure where it clips in exactly. Any idea? I didn't see you attach the clip to the inside pad in the video, unless you did so off camera. I have the same make, year and model mitsubishi shogun

Yes enjoyed the video and instructions plus of course the seagulls.

Please what size thread is used for the locking bolts on the pump and timing gear?

Thanks for this video, it was a perfect guide to replace airbags on mine Thanks LEGEND Any idea on how to reset the airbag ecu?

Thanks for this video, it was a perfect guide to replace airbags on mine Thanks LEGEND Any idea on how to reset the airbag ecu?

How do you get the seat up

Marge Land

Number 1 of head I think that is side right and number 4 side left

THANKS FROM BOSTON MASSACHUSETTS I'M HAVING A PROBLEM NOW WITH A 06 CAMRY FLEX

wtf is a c5 nut? I saw this car in Westfcroft it so pointless

Informative video! I want to install a hitch plug on a golf mk1. They sell some hitch sets with or without a kindoff electronic module. Do I need one in my case?

Thanks for sharing this. I am about to change the belt on my Lada Niva 1900D which has the same engine. Didn't know about the timing holes, that's pretty neat! No need to fool around with marking the wheels or the belt.

Interval of change km?

I have several LDV 200s that have this XUD9 engine fitted. They ran from about 1994 up the early 2000s before moving on to the DW8 version.

Can you remember the diameter of the pipe? Thanks

Were they making a noise? Did you have an issue? I’ve got an auto box and getting a big whining noise when up to temperature on faster roads. Final drive into box is a potential issue. Everything else is brand new.

Do you have to reset the pressure plate? .. because i followed this ans now i have clutch slip 🤔

Really struggling to find air temp sensor citroen dispatch 2.0hdi 2011 anyone know location 😢

u must have cut it to short

hi what is the brand on the full exhaust? i need to replace my back box and want a genuine 1.

Hello, I have a red zx 1.9D in Madrid. If you want to ser it, you have a home here where to stay

I do mix my biodiesel down to 50:50 with settled veg oil, and at least as far as VW 1.9Tdi ALH engine is concerned, it seems to run very, very good. Not so good on straight diesel.

Good Job...Great

Hi there, thanks for the great video it was very helpful. Do you know how much oil goes in the gearbox ?

Mine work but turn off up

Great video dude, was wondering if you've done a video on adjusting the handbrake? I've actually got an expert tepee but I think it's the same

Thanks for help

Thank you!

can slap a little bit of duct tape on that cover to shut it up a little.

I have exactly this problem tonight with wipers seized at exact same angle as video It's the second time in six months this has happened. This video is clear on what needs done

When are you doing the white Zx ?

Your video is helping me a lot but i got stuck right before pulling the dash off. One question, do you remember if You had to pull of some windshield vent conduct? My dash seems to be stuck in the middle

Cheers for the info.

What head is on the screws to remove the airbag from the steering wheel? Struggling 😢

Спасибо для твоя работа

I used plate glass and got the block super level it took 2 weeks of sanding to get if perfect but the head sealed with no leaks and still going strong after 2 year's. The turbo xud9te-l engine block doesn't have any gap's inbetween the inner wall of the cylinders.

Hello, sorry if I'm annoying. I just wanted to ask a question that has nothing to do with the video. In England, are there restrictions prohibiting the use of cars without an environmental label? I live in a town in Madrid, and they have told me that in a few months I will not be able to drive my zx 1.9 Diesel outside my town

Did you use any torque specs on the bolts?

Very informative