- 6
- 32 783
MrBobbyCookson
Приєднався 25 лип 2011
Відео
Leds from 9 volt battery
Переглядів 104 роки тому
Couldn't find anything to help that didn't assume you knew everything about electrics, resistors and so on so here's a vid with what to solder where to run 5mm leds off a 9v battery.
How to check F1 code on a Suzuki bandit 1250
Переглядів 32 тис.6 років тому
How to see the error code on a suzuki bandit 1250 using a bit of wire and 5 minutes work.
Final pride boy video
Переглядів 1046 років тому
An idea that was great until i started then i realised how much work it was going to take.
ha ha ha
Переглядів 259 років тому
MOV00025
Переглядів 1313 років тому
At the moment my light only comes and goes infrequently. Must I wait for it to be a permanent red FI light before I can try this?
Hey man, thanks for the video, my bandit 650 had the ''fi'' light up this weekend. It was the ''C44'' code, O2 sensor fault, bought a second hand one for 30€ 👌
this is Fuel Incjection system fault (FI) not F One code. Short wire circuit connection runs CPU in diagnostic mode, and then U can read fault codes from CPU.
C42?
good man
so does that mean you dont need a error code reader them
Do not get the 3 thumbs-down at all. Very useful informative short video.
not bikers lol great video simple and to the point
short and simple...no waffle..thanks. the thunbs down were from people expecting a UA-cam video to magically fix their bike without spannering!!
I have a problem on my gsf 650s. Sometimes pop out check. And i don't have any trouble with starting motorcycle and driveing. Work's fine. Everything work fine except sometime pop out check
_C00 doesn't it mean your TPS is off?
I thought it means that the idle speed is set too low. If the idle speed is set correct, it should show -C00
Best version on here.
Awesome
Tranks bro, you save my life!
Looks shit mate lol.