Відео

Nice! Where do you sell this tool? Do you maybe also make the “castle” tool? Those are hard to find for my older model Lefty UltraMax fork!

Bearings can be held in place with rubber band or a cut old innertube.

I'm restoring an old Killer V, thanks so much for the vid.

Great video. I just aquired a 1997 Cannondale Killer V900 HT with DD60. i'm loving learning about the Headshocks. thank you. cheers from Nova Scotia , Canada !

Bellows on before the locking ring; right?

no need special tools. i think use dick tape can hold the steel plate. i guest!!!

I was hoping to see start to finish😂

master

Where can I get this tool?

Oh there's a special tool. I did this freestyle. Took about 20 goes over a week to get everything to sync up. Never ever again. Get a saucepan, heat up the grease and pour it in. After washing out of course.

Can I send you my headshok

Is it possible to completely remove the internal suspension from the headset and also the bellows, still keeping the fatty fork turning it into a rigid fork? Should hereby the headset be exchanged or could the now exceeding 5-6-7 cm after the removing the bellows easily be cut away, where now the fork would stick practically to the headset? The slight downwards rotation of the frame and the reduction of the clearance under the bottom bracket are taken into account. If all possible, how would the procedure look like? Thanks

bautiful job

You didnt rebuild it, just simply put part of it back together…

Hi- do the bearings come pre greased or does it need to be done during assembly? Thanks

i needed this back in 1998 ;)

Would clamping the fork for example in a bench vice make use of the jigs superfluous? Very well done btw. Skillfully assembled.

Thanx man❤

Was hoping to actually see the fork work on a bike.

Hey bro, where can i get e parts for headshok? Racing needles, cartridge damper, oil seal etc

Which is the maximum inflation pressure?

Awesome Roc Fu. You have sure simplified the process of rebuilding a head shoc.

Where get all rest of parts?????

great tutorial, i ´ve same fatty SL. ... thnks so much, where i can buy a kit of bearings and the eight (8) laminates ? pls ask me , thnks so much, atte Oscar

I have read in the Coda technical manual you can use cuttings of bicycle inner tube to hold the inner races and bearings into place. If you don't have the special tools that is.

my god what a shit, simple rubber rings do it exactly the same and even faster!

no way that you need a $90 tool that you just slide the needle bearings into for 10 seconds.

MOST EXCELLENT WHAT KIND OF GREASE DID YOU USE.

This is awesome tool do you now were I can get new bearings

How much cost for that tools?