Відео

I like how you hold the hammer when distressing in a dristressing way😂

Great work restoring door.

Need a gap for expansion and caulk. That’s installed incorrectly

Video content is always great!

Over kill

Schluter wants a minimum of 3/16 gap All the way around for proper drainage.

Looks cool, but does that stretching at the corners either weaken the fabric or more importantly tear or shrink?

The odd missed nail not a big deal. Lots of roof nails going through after. Don't waste your time.

Would’ve looked better if you plastered it to keep it hidden. Now it looks like eye soar. But I guess I’m not looking at it everyday - you are.

Why use plastic biscuits?

I'm sorry sir but I'm going to have to disagree with you the most important thing is you hire Americans to do your work not Invaders.

Tape is better. Faster Cleaner. This is only Harder!!! No way

Messy shit instead pf simple wrap material? Un genius. Way too make it Harder and Longer and Mrssy af. Dumb Af

This trend is so pointless

Ok bro. There was barely even one thing that was EASY to simpletons on this video. 🤣. Even for advanced pros this is a meticulous project. You guys did a great job as always. I was more surprised you didn’t whhip out the biscuit jig lol

The single most expensive thing in my house will be my Roof, and my Floors. I am not using Chip Board, I am using Solid Sheets of Lumber and its going to be Strong Lumber. I never want to have an issue with the roofs structural integrity. Ever.

Clean work as always

I had a buddy that decked his two-story 6/12 pitched roof with ridiculously heavy 1 inch HEAVY fiberboard! 😂😂

Tuba tubes.

Right on coach 🫡

Imagine what the living space looks like if the garage looks the detailed

If you’re not gonna fill the nail hole than mine as well just LEAVE IT in there.

This is badass.

You need a lock joint bit for your router table. The end product is so much nicer, stronger and easier to finish.

You need a lock joint bit for your router table.

Better to see the Shriners in a parade than rows of Shiners in an attic

Eliminate the faux beams against the walls, the load bearing walls will carry that ceiling/roof weight.

Where’s the decking clips? You’re right about the layout but without the “H” clips you’re gonna damage the roofing every time someone walks on it.

Damn super clean look. Get it coach!

Looks good awesome job!

You can use tape to close those miters and won't need as many mechanical fasteners

Dude, sick.

Love the trash under the steps only pros do that

Tuba toos

awesome job

Nice

Nice

Agreed

loved the series and looking forward to seeing your new house being built!

Looks good man.

Tight at the end of your string and half inch gap in the center?

Beer a shiner is what I get charged

Where are you getting that stretch tape from?

Here in Florida, more than 3 shiners is a FAIL!

Noice, the feet won’t feel like your on a Rubbermaid garbage can cover ! Solid ! 👊👍😎

You really do great work - got it coach! 🤠

Great job...although there are prodicts that do the same thing that are much more efficient and quicker to install.

Good job. Been doing that for 40 years. Not seen anyone else do it. Again a great job

I’d actually like to know if there are any houses in the Us anymore built properly. It’s all Mexican labor and corner cutters. I bet most houses these days are just 50% of what they’re designed to be quality wise.

Have a genuine question and I have asked all over reddit and can't get a real answer.. I need to cover exposed faced insulation on ceiling in garage and looking for non-drywall ideas to get it covered so it's not a fire hazard