Відео

What is the best battery ratchet to use

👍👍👍👍

Great and excellent video 💪🏾👍🏽

service that ptu lol

Are 2013 and 2016 similar in this process are there any major differences that you are aware of?

My 2013 altima is at AAMCO right now getting the transmission replaced. Now i know why it is so expensive. Thanks

Just straight to the point video no talking,

Is there better way to lift it up from top ?

I was wondering if this is the same as a 2018 Ford Fusion 2.5?

Can a 5.7 l small replace the 2.0 engine in these cars?

Did you have to unbolt the torque converter before pulling the motor

Great Video. Do you have to pull the exhaust system?

Hi, I'm just curious. What part of Ohio are you in? Do you work on Toyota's?

how do you remember where all the screws go?

I think, just buy a new car.The time u spend in dismantling, then repairing, then re installing, do u even make minimum wage?

It’s been 4 years, I understand. But however, I’m in the middle of an engine replacement in a 2015 Durango with the 3.6. New engine is in, but I can’t get the torque converter to spin around freely to line up with the flex plate bolt holes. Did you have this problem?

Where are you from?

I didn't see an engine bar holding up the engine or a jack below. I also only saw onr motor mount. How is this engine hanging? Lol

Just found out my transmission is going to need replacement. How many book hours should i expect it to take?

What state are u in?

What are all of the major parts you had to remove in order to remove the engine? Btw love the video but I wish you could have mentioned each step as you worked

How many bellhouse bolts should it be

What’s the star socket called? And what size is it?

I this time lapsed ??? 39 mins. Is AWESOME !!!

Is there a difference between a transmission with a plastic valve body pan and a metal valve body pan? Will a transmission with a plastic body pan fit a hyundai that had a metal body pan?

That fuckin Matco puts in work gawd damn

Help. 2006 mazda 5, i got the transmission installed and when into tighten the trans ti engine bolts i can bearly trun the engine over.

I'm getting this done right now to my car had 130,000 miles on it and the only reason why they're doing it for free is because I got all oil changes done the dealership

CAN I REPLACE A 4 cylinder EQUINOX with a V6 ENGINE?

You don't need to take the drive shafts out of the Hubs at all nor remove the Hub nuts. For the drive shaft that's in two halves, separate the halves at the bearing support bracket BEFORE you remove it by tapping with a block of wood and a hammer. Take the halfshaft off the spline and leave it in the Hub, tuck it in the wheel arch out of your way, then remove the bearing support bracket complete with the other halfshaft, For the other side driveshaft. once the lower ball joint is undone, there's plenty of play in the suspension leg to take the driveshaft out of the transmission, and tuck it out of the way completely. Messing about removing the driveshafts from the hubs, hoping they're not seized is unnecessary and adds anywhere from 20 minutes to a whole day to the job, depending if they're seized in the hubs or not. No need to touch them.

That was awessome, you are the Master !!

Dude the video is on point you are an awesome tech

Silent!

I have this exact car and the transmission is messing up, how long did it take to remove and replace the transmission? Was it costly to do?

Easier pulling from the top!!!

One thing i'll never complain about is prices for transmission work. Mechanics deserve that money

اخي لاتوريد عامل

Nissan's throw away transmission

Is this the same for a 2014 Taurus 3.5 liter good video

A bang up job ; but I think I will pass ....LOL

How did you rotate that wheel in the transmission to get those Avalon bolts out

Video is about worthless with no audio

Im more impressed he beat on that harbor freight pry bar without breaking it

Im more impressed he beat on that harbor freight pry bar without breaking it

Is this an AWD equinox?

Where do I get those plugs for the lines and what are they called

I'm terrified my '15 Altima tranny is gonna go. So far so good tho. Do you think living in a cold state helps? Thanks for the video!

Excellent. Thank you. I couldn't decide weather to pull from the top or drop it. I'll have it out in a couple hours now.

Do any brake lines need removal or opened up?

Love the video. I was quoted 2k in Ohio to replace this at a local shop. The upgraded part to correct the issue is $117. I’ll be doing this myself now. Thanks bud