Відео

I upgraded my Hatsan flash with an Altaros regulator, this short video shows you some of the steps that may help you make the decision to install one yourself. The instructions for installing this Altaros regulator are on the Altaros website and give more detail to their specific product and how to install it. In the end, I was not able to get good chronograph measurements due to the valve lea...

Hopefully a quick fix to your line 6 Helix Floor. I followed the instructions and still ended up with the Boot Failure connection problem. Still need to make sure you bring your Line 6 updater and HX edit up to the current version but instead of trying a bunch of different USB cables, different computers, uninstalling and reinstalling, and every other frustrating trick you can think of, just ex...

RAW HM1000x  this was my fifth attempt to fix the leak and at the end, it still leaked, and I thought I failed and was going to just put the gun away for a while. Then after thinking about it for a few minutes and how the air had to flow past the valve, it clicked that the little black piece of plastic on the end of the spring was part of the valve and had to be what was leaking. Near the end ...

This is my third attempt and I’m the end it is better but still leaks. I ordered the o ring kit from RAW and the kit includes everything except the one o ring I really need. I have now ordered the new valve and will soon make a video on that.

This video is me disassembling and replacing some O-rings in my rapid air weapons HM 1000 X. In the end I am unsuccessful at stopping the leak but at least now that I’ve been into the airgun I have a better understanding of how it works. I later found out That there are O-rings inside the brass valve and I suspect that they are what need to be replaced. Comment below if you have had the same pr...

This is my second time out shooting my Condor SS .22 with the new regulator installed. The tune shoots good groups at 15 yards at 850-860 FPS with the hammer set at 1.1 and the .145 ring loc valve cap. Sorry for the sound volume being low and not moving the target in so you can see the groups. I think I will try the .166 valve cap and see if I can get a little higher velocity.

Airforce Condor SS .22 tune and velocity recording after installation of Altaros regulator. With the factory valve lock cap that is larger than the .232 we only got about 45 shots before we fell below the regulator setting of 105 BAR shooting around 940-950 FPS. Then with the .145 valve lock cap we got around 85 shots at 860-880 FPS. Pellets used Crosman 14.3 gr hollow point

I just installed a new regulator on my Condor and now need to fix a leak that I caused by using the burst disk port to remove the air and install a plug were the old fill port was. This is a short video on what I did to remedy the problem but am also looking for ideas on how others fixed the same problem.

This is intended to be a short video to give some guidance on the installation of an altaros regulator on a Air Force condor. SS 22. In this video, I try to point out a few of the hang ups that are not so well explained in the instructions, I did run into a few problems on this install and hopefully my mistakes can help your install go better. This video turned out a little longer than I wante...

Technics SA-400 trouble shoot and replace Darlington power pack. This receiver blew a fuse during a test on some speakers and making some adjustments on the bass.

Clean potentiometers on a Peavey chorus 400 vintage amplifier.

I install driver door glass in a Chevy HHR. Hope this video helps anyone that has the same task to perform.

Made a repair on a Realistic STA 77 using the seek thermal infrared camera to identify the failed part then scanned it again after repair. I also used a meter to prove the failed transistor. I hope this video is helpful for others looking to make similar repairs. Remember safety and check for voltage before performing work by qualified personal.