Відео

What did you use to lubricate the bearings?

fiddy nine

Buy new seat covers.

You the man ray

That’s Awesome teamwork!

Thank you so much from across the pond to you and your wife for taking the time to video and post it. 4 hours, numb fingers, a scratched head from clutch pedal and some choice words and the issue is resolved! Those screws are just plain sadistic! But patience prevailed and all for £20 parts. Thanks

Great video! I’m not sure if you know but can you readjust the wire on the wheel?

How do you get the window to roll down if it's stuck in the full upright position?

Thank you so much, your video is a BIG help.

Well what type of silicone did you use? Did you use the one suggested? Also you did not mix the paint with the silicone first. Also dogs on leather just negated the who video lol.. 🤔 😂

Great Video!!!! Us 2 Old Guy's followed your directions to a tee. Even had the same bloopers you did. Thank You very much. Your help was Greatly Appreciated!!!❤❤🙏👍

😁 "Promosm"

I replaced the brake light switch and the problem is gone.

Been trying to fit into the footwell to remove this very part and actually called it quits last attempt, I can safely say, your wife's a godsend! Congrats!

Did the cameras work after this

So this is better than those patches they advertise online? More permanent?

Sorry to ask on this video but I found your fix the shower door video and I have the exact problem. Could I bother to ask what was the length and diameter of the small metal cylinder and where was it purchased? I’ve been searching for a metal piece to work but no luck. Thank you.

Excelente

I won't state the obvious. No, not that YOU did great for a woman. It's that Ray?got you flustered. You are Ms Mechanic, if you wanna be.

Vegetarians always trying to make fake hamburgers. Ketonians always trying to make fake bread.

Great job! Thanks helped a lot!

Will this effect a “trade in”.. like would they rip the back off just to see if it was replaced?

Can this still be done with the window down (front drivers side) since a reulator usually goes with the window down? I think i hear the cable off on mine like your video

Great job. Ive done these before except I invlolve a lot more cussing taking in and out the regulator

I think you have damaged the coil charger for this iphone. That's why I prefer and am willing to pay more to repair the iPhone in the store because it is still under their warranty if damage occurs

Great Job & Congrats Alyssa! -Your Friendly Practically Family Neighborhood Spiderman 😂😂😂

My friend I don't know if that's your daughter or your wife but I can assure you the best part I seen wasn't the door regulator it was her she's a keeper you guys are awesome👍🙏

i like the tape idea.

Any idea what the difference might be to do an 2018 odyssey?

Awesome video and thanks Zoe. Unreal how easy you made that for me. Thanks.

You DO NOT put anti seize on those plugs. They already have it on them. This comes from NKG. You made a mistake.

I guess this video has some value, but come on guy don't you feel any type of responsibility creating content to put out something that works. Even with skipping through the majority of the video still these videos should offer a solution to a problem, I feel like I just watched a Kardashian episode.

Great video, thanks for sharing. The process I use: EQUIPMENT IPA wipe or solution 340 grit sandpaper sample pot of latex rubber solution Stormshore flexible adhesive (or similar - any glue that is designed to fix inflatable paddling pools etc will work) Strong duct tape dish soap leather spray paint sharp scissors METHOD cut fibres away from the edge of the repair. sand the edge of the repair (don't spread the area of the repair too far from the edge) cut a piece of duct tape slightly larger than the hole or tear area (5mm larger all round) carefully tuck the duct tape into the hole or tear (sticky side up) so the duct tape sticks to the underside of the leather choose an area of the seat that has a good leather textured pattern remaining (if the leather is textured) and clean with an IPA wipe. Then spread a thin layer of dish soap over this area (this is the release agent for the latex rubber). Poor a thin layer of latex rubber over the area (about 10cm x 10cm area) and leave to dry. Repeat this process until you have a 2 - 3mm thick patch. Peel the latex rubber mould off the seat. This will act as a texture stamp. Next, clean the area around the repair with an IPA wipe or solution (important to allow the paint to adhere to the leather) Place a small amount of glue into the repair area and level out. Allow to dry then repeat the process until the repair area is flush with the leather. Allow the last glue layer to just start drying and spread a small amount of dish soap over the surface. Then push the latex mould onto the glue to transfer the textured leather pattern onto the glue surface. Remove the latex texture stamp and leave overnight for the glue to cure fully. Clean with an IPA wipe, leave to dry and spray with the leather paint (mask off the area if necessary). Job done.

You butchered that poor phone. Should have taken it to a local shop instead…

Good video... :)

im if the phone falls it will break again because you didnt glue the back with a B700 glue

good job.....thanks for the video!!!

Where do you buy this silicone filles?

2006 Ford f150 super cab OEM rear window regulator needs a new nut for the new bracket style. Nut at this time does not come with purchase nor did they tell me i needed one. The nut will be same size for screws that hold regulator in place.

I hesitated, then thought that since I suck at car stuff might be best to watch a girl do the plug change. Good choice on my part. It's a great paced video and covers some small items that will help but weren't covered in other vids I looked at. I think it's specifically because this is a female narrated and done video that it is produced that way. Diversity at it's best 😘

decent video. just remove the music. its irritating and not necessary

Thanks great video I’m ready now.

Very awesome, You've helped me Troubleshoot 👍😌.

Great video. It sure give me the confidence to change it now on my wife 2013 Odyssey.

My Chicken Is Suffering from a fly strike what to do now? He is restless and unconscious

I have completed this process to with silicon filler. Try next time on the tears buy a permatex deluxe leather repair kit. The kit will allow you to make a flat or textured surface over the silicon repair. After painting it's less noticeable where the fix is. That's been my findings on completing a DIY restoration project of BMW M3 seats. Thanks for your video. I enjoyed watching it.

You needed a heater in the garage or to bring the seat into the house. That adhesive won't work in low temps.

The reason I’m replacing my back is because I took it to apple to get a battery replacement and they told me I would just have to replace the phone. If I took it to apple now to get it replaced, would they still turn me down?

140K

How many miles on those plugs? Thanks for showing how the back plugs are done since most other videos don’t. I love the towel over the manifold trick!