Відео

Strange. My 2003 AC 300 4x4 has a female end on the CV joint cup and the male end shaft (with a cir clip) is in the differential. It just pulls out. It's almost backwards of this setup.

My shifter is stuck

What is the plug at the top of the case for?

so what about the tranny filter?

Would you recommend to do it on the scat track Mohawks the Mohawks rub a lot

Thanks!!!!! Always good to see it done before tackling it yourself.

Had the exact situation with my 550 and couldn’t get it out. After being told that it just “pulls out” I’d about given up. Saw this a couple of days ago and just tried it with my vice grip slide hammer. Came out with 2 fairly easy hits. Thank you so much for this short and to the point video.

Awesome video. Thank you sir

I wish I could see where the shims go.

How did you get the bearing out of the cv axle cup

I’m coming up on my 20 hour break in. Thanks for the video, big help

Thank you sir! Those 2 screws in the middle where holding me up till I found this video. 👍

Thanks for this video. I have a 2017 Sport ad couldn’t figure out how to get the 17 mm fill plug out of the front diff. You saved the day by showing the crows foot wrench you used. What a shiny design they used for the location of their drain plugs, no room to work ! Thanks again for your informative videos. 👍

Don't need no fuse block. Need my wildcat to stop overheating and stop the gear jamming. Stopped making this SXS . They should have but they should repair their defective product.

You are a saint. Thank you

You have got the BEST video on how to remove this.. THANK YOU SO MUCH

I'm changing out my thermostat this weekend on my 2017 WC Trail. Great job showing how to remove the bed. Thank you.

Holy Christ dude I wanna tongue kiss you right now I been working for hours before I found this video “many cuss words” THANK YOU!!!

Not heavy enough material on the A arm. The bolts can't be tight, or the suspension won't travel travel correctly.

FYI: Yamaha call it a final drive and not a differential because it's not a differential. Differentials are much more complicated because they allow the wheels to turn at differential speeds. The wheels on a YXZ always turn at the same speed.

I know this is an old video, but I had a rear axle go bad. It was this type with the ball. I cannot find this type anywhere. They all just have a circlip. My dealer cannot even order them it seems and when he called arctic cat they acted like they know nothing about the ball type as seen in this video.

You don’t even need to take the clutch off

What could the issue be when it’s a little difficult to switch in and out of gears?

Bad driver

What if I have a Polaris rzr? Same concept?

Are you able to access all of the bolts from underneath the bed?

What Years Does This Cover ?? I Have a 2003 .. Thanks

What if it’s too bent to spin it around with the 14mm wrench?

She musta been outta balance. Lol

Straight up, no BS = 1 new subscriber. Thanks for quality shoot

Great video

I have already kept 400 trying to get that center cap out but it don't have a ball solid right there how do I get it removed

Thanks for the video i have been struggling....

Thanks, do these instructions apply to a Trail 700?

One of the best how to do video I have watched thanks

1st off, I have Never commented on anything before. I was trying to get it off for hours. Come a cross you're video. Had it off in 10seconds, NO lie 10 Both side. Thank you

Great instuctional video well done

Mines a 2018 wild cat sport same issue… I fix that that piece of shit more than I ride it never again will I buy an Arctic cat!!! JUNK!!!!!

Great clutch install, noticed the TK sticker , myself retired Local 18

Thanks for the video. Yamaha could have made it a lot easier. Pain in the Ass

My clutch is right on the floor,push really hard to disengage but grabs immediately, I bought the buggy used so I’m thinking it’s time for a new clutch?

I assume if the clutch pedal had been adjusted as the old clutch wore that it would need to be backed of after new clutch is installed

Thank you for the video

I went to remove the CV axle today in my side by side and it came apart were this one did now I know how to remove the rest of it this video was a big help thanks

Great video good to know information, nothing in the manual about this Thanks again

My 2014 wildcat trail 700 keeps braking belts. I've put on several different types. What could be the problem??

How do you replace the Arctic Cat 0648-826 CAM,BACK-2 STRK. Please

Do you know what the size the axle nut is …29 or 30 mm ? Thanks

The biggest problem I see with artic cat is people still buying them

Gotta love the wildcat trail