Відео

Yes, first need to remove cap, and then you need to grind around 1mm. It is welded, so hitting in first place don't work. Grind slowly until you can see, that welding is gone and you can hit or pull out the killer.

ona pregunta tengo fallo di calendario cuando tsubway cable de corriente si salta tomaco

si salta automático

Not really, some weeks after i went for service, where they fine tuned carburetor, but it went better- power and motor rhythm, (Better when i drove out from shop with Db killer) So no difference without any fine tuning with or without dB killer.

I have not plan to put it back, I will do it when i go yearly inspection and as it is quite tight, i will put that in and let it heat, so it expands and not coming out, After cool down i take it out again. If i need to put it back permanent i would drill hole and use one rivet from side.

www.dropbox.com/s/krr1qtmyvofs94b/Hammakas.dxf?dl=0

Try to create a support ticket, they replace my 2021 ring this week due to battery issues.

It need's testing. If you do nearly 100% filling it is strong enough. How fast it ware out- don't know.

can you show picture?

good to hear!

Did you get the cap out before removing the db killer off? I m pulling with all my strenght and still i wasnt able to take it out :(. I was afraid of making any damage...... I was moving the whole bike but the DB Killer strong as a rock! Didnt move at all

@@proracing34_Athens yes i did remove the cap, i hope you did also before starting to grind haha. Its just 3 bolt and easy to remove. Then you gotta make sure you grind away all the welding otherwise it will be hard to pull it off, only the smallest bit of weld left and it will sit very strong. I did it in steps with some grinding then trying to pull and then more grinding if it didnt come out and just kept on doing that.

@@philipkarlsson1296 wow thank you for the info . I ve lost 2 kilos today pulling and pulling without doing anything!!! And I stopped when I started having thoughts of damaging the exhaust... Let me ask one more thing. If I take it out then it won't get back in right?

@@proracing34_Athens haha i can understand that! That is correct, if you do this you can not put it back, only with welding.

Hi, Glossy part can't be removed, as it is is under the regular matt layer. Only solution is full paintjob ( or sticker) for the tank or leave it just it is

@@TheLauri5678 right! Tks for reply. I just leave it just it is ✌🏻

www.dropbox.com/s/krr1qtmyvofs94b/Hammakas.dxf?dl=0

www.dropbox.com/s/krr1qtmyvofs94b/Hammakas.dxf?dl=0

i think the wheel diameter should be same.

The most useless comment ever :-)

Hi, Thanks, File you can download here: www.dropbox.com/s/krr1qtmyvofs94b/Hammakas.dxf?dl=0

Hi, File you can download here: www.dropbox.com/s/krr1qtmyvofs94b/Hammakas.dxf?dl=0

You can print out this file on the normal paper and cut it out by hand with metal saw etc..

Thanks!