- 5
- 144 005
Raphael Gluzman
Приєднався 23 лют 2013
Відео
Audi A4 B6 ignition switch removal
Переглядів 3,6 тис.3 роки тому
2002 Audi a4 easy ignition switch and housing removal
Simple smoke machine
Переглядів 2099 років тому
Panasonic SB-WA310 subwoofer connections. Second try
Переглядів 132 тис.11 років тому
via UA-cam Capture
Just a bit, the important screws for electronics removal.......on the bottom!
Como hago para activar este 4:29 4:29
I have a a woofer model number s b w a 330
Do you have the serial number of the model number of sbwa330
No I dont
I need model number sbw A330
Hey Raphael! Your comments are off for the video 2005 ram rollover valve repair so I figured id comment here hope you dont mind need some help I got a 05 ram and had to repair the vent tube nipple to because the person before me snapped it and the gas pump would click off everytime filling up and now that I've drilled and added a rollpin and epoxy. it takes fuel without clicking off at the pump, but I've noticed these past few days no matter the amount of fuel I add at the pump the truck struggles to start unless I put my foot on the throttle a bit while cranking then it runs rough for 4 seconds then clears up, Then I tried refueling with leaving the truck running and it started running rough wanting to die so I just shut it off and refueling then went back in cranking with foot on pedal slightly and started ran rough for a few then cleared, I thought this was my purge valve so I replaced it ended up not fixing it so bought another purge valve thinking I got unlucky with a faulty one lol but nope I have a feeling my engine is flooding with fuel vapors or fuel not sure but only happens really when adding fuel I'd love to buy a new tank but like u said they are expensive any advice man? Thanks in advanced
Did you replace the purge valve or the vent valve? The purge valve is under the battery and you can simply disconnect the wires to it or even better, the hoses and plug them. You will get a check engine light but the problem should stop if it realy an issue with the tank or fuel getting into your intake. It sounds much like the issue I had with the rollover valve. When you fill the tank to the top and that valve doesn't shuts off, the fuel flood the vapor canister and then being sucked into the intake
@raphaelgluzman4933 I replaced the purge valve and fixed the vent nipple on the roll over valve on top of tank and ended up replacing egr valve and throttle body my vehicle still struggles to start after adding fuel to the tank unless I press on gas a bit then crank it runs rough then clears out I noticed if I go over half a tank of fuel the truck will run weird when going into gear like when I go into Drive the rpms drop like the engine is going to die then comes back up and if I'm on any sort of incline with over half a tank the truck starts running like crap I'm thinking like u said in the video that other line on the roll over valve is getting gas into it sendingit to the vapor canister or something my next purchase is a vapor canister but I think it may be the tank that's causing my trucks problems
@@evanfrasier I'm not sure I explained it clearly. Let me try again. If your rollover valve (the white tower) is defective, it will allow liquid fuel to enter the canister and then when the purge valve opens it flood the intake manifold with fuel. The way to test it is to disconnect the purge valve see it doesn't open. If your symptoms go away than thats your problem. The brass part on top of the nipple I installed on the tank is an after market rollover valve to replace the defective one. Just for your info, the canister can be repaired by replacing the charcoal with charcoal for a fish tank. About $20
@raphaelgluzman4933 Oh my bad, now I understand what you're saying, so for the purge valve, do I just disconnect the electrical connector? Or do I also unplug the two hoses going to it cause I believe my roll over valve is defective sending fuel ti my canister and to the intake manifold exactly like what u said. I am going to replace the charcoal canister but I'm thinking I should put a new valve in like u did on my tank. The tank in the video u made is the same exact tank on mine with that broken nipple/fitting
@@evanfrasier if your purge vakve is good you can just unplug the electrical connector. You'll get a check engine light
Gracias !!! desde Bolivia me sirvió de mucho el video, ahora puedo escuchar músicaaaaa
Buenas tardes yo acabo de comprar el subwoofer el mismo modelo como lo adaptaste o modificaste su salida por favor espero su respuesta
This is exactly what I needed, thank you
Brasil Agradece Aqui não Tem Técnico ensinando a fazer essas ligações consegui fazer no meu muito
Hola como ases
Thank you, I bought a Bluetooth to RCA connector, works great. Thanks again
Hola como isistes la coneccion para que funcione con el bluetoo
Yo también estoy interesado en saber se lo agradecería
@@Lucas-wc3sw gay un aparato que venden en Amazon, RCA to Bluetooth
I have a Dump sir
How did you remove the safety cable?
Sorry, I don't remember but it looks like there is a slot for a clip
@@raphaelgluzman4933 i removed the clip, but the steel cable is still in the ignition cylinder. Will try to squeeze a small screwdriver in there.
Good luck. I didn't enjoy working on that car. Replaced it with a bmw. Much easier to work on and the parts are cheaper
You have to turn the key in order to unlock that cable In the back
I could connect it what I can't is to go up and down volume
El videos es genial
Hello, good afternoon, can you give me the order in which you tell the pins
Hoy 01/17/2023 relise el proceso y quedo funcionando super bien, recupere mi teatro en casa..gracias
Yo lo hice con el modelo SB-WA720.. lo que no me gustó y también pasa en este vídeo es que entra voz al bajo.. no sé si sea que lo estamos conectando directamente por RCA y el DVD sea el que maneje el crossover o nos falta conectar o puentear algo.. estaría genial resolver ese problema 🤔
Hola es necesario el dvd o se puede aser solo con el bufer
@@jacofebrero Solo con el bufer, este metodo es para cuando ya no funciona el DVD.
I really like the video you made for the subwoofer sb wa310 I have the same one I tried but I failed Really hope to have some help from you . I can pay if you can help . Thank you so so much
I have the same subwoofer like you but still can’t connect Can some one please help me I would pay for this ! 🥺
What parameters does the fan have? Is it 12V? What are the dimensions of the fan?
Hey man, whats the voltage between the fuse and the brown wire going to the transformer. I want to make sure my switch wont melt, thanks 😂😂
It's been so long. I think it was like voltage. 120vac
Wish I know how to do this too
El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....
Hi I also bought this by mistake from someone in Australia. Now the connecting cable is not compatible with my tv. What to do
El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....
@@wilsonsalazarm4056va a sonar el sistema o otro sistema?
Wow! It really is amazing the hints on something so obscure that I can find about a sub posted eight years ago!
I have the same subwoofer (powered subwoofer only), could you help me & explain how I could connect it to a stereo receiver? Thanks & Thanks for posting this video
Interessante, eu achei na rua um desse porém o modelo 510, não sei se é a mesma os menos pinos, mas irei testar! Obrigado
Hello. please tell me how to activate the relay on the power board
L pin = 7 R pin = 6 GND pin =? Subwoofer pin = 17 yes? (sorry i not speak english) please help
suena ese subwoofer o otro sonido?
Great video! Please could you confirm if the 25 pin cable “pin-out” is just straight? Or maybe crossover? I lost it so I want to build a new one but need to confirm if PIN 1 is also PIN1 in the other end. Thanks in advance!
Hi I also bought this by mistake from someone in Australia. Now the connecting cable is not compatible with my tv. What to do ?
hello. dear author, I do not know English, and therefore I did not understand how to connect a subwoofer without a dvd. please explain in more detail once again. thank you very much
El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....
How did u connected thę aux?
El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....
I just got the SB-WA340 subwoofer with its cable and with your video I managed to get it all hooked up in next to no time, thankyou! another working system saved from landfill!
turn your camera
Making the jumper of the fuse turns on the fan and so we realize that it is already activated
Al hacer el jumper no se enciende el ventilador
Thank you!!
heloo ,,I don't have a palette, and I want to take it to the aux. I drink the same dots but it doesn't come out, you have no other video?
Я все подключил кому нужно пишите ❤️
Мне нужно! По тарабарски не разумею)). Зачем он красным проводом с крокодильчиками предохранитель с чем то там ( тоже пока не понял) замкнул?
ALGUEM PODERIA LEGENDAR EM PORTUGUÊS? Someone, maybe the owner of the channel, could subtitle in Portuguese? Thanks!
Eu entendi o básico, se quiser pode me chamar.
Tried your suggested by pass. Doesn’t work
6 years later and still helping people! Thanks guy
COuld you please tell me what the other white wire going from iPod into the case/amp is? Thank you.
El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....
hi im just wanna say thank for the video it was really helpful and great explanation. i have a question i hope you can help me with that. it is possible to connect any switch to turn it on and of and also to increase or decrease the volume¿ thanks have a nice day or night .
AMIGO BUENAS TARDES PODRIAS EXPLICARME DETALLADAMENTE COMO LO HICISTE POR FAVOR EN ESPAÑOL -GRACIAS
i have similar model, i need help making mine work with my mobile mp3 player. Mine has two fuse, and mine shows green light constantly at the front.
El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....
Don't you have orginal black connector ???
Thanks, worked perfectly....
All the pinouts are listed above - you just need to connect the appropriate RCA outputs from your HD amp to the appropriate pins on the system cable and bridge pins 6 and 13. To turn the amp on or off, bridge pins 4 and 19
BUENAS TARDES PODRIA EXPICARMELO MEJOR EN ESPAÑOL.GRACIAS
@@sermat1000 El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....
My friend, I want to cook with more detail when it's time to call. Thank you.
How did you wire the aux cable ?
El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....
@@wilsonsalazarm4056 como se pide ese cable auxiliar?
@@lopezcastanedamichellherna7330 CABLE RCA 2 X 2, viene con los terminales color blanco y rojo como el de los DVD
Very thanks for you.
any insight on how to splice system cable to an RCA cable(only for subwoofer) coming from amp?? or if it would even work.
just put it in pin 17 and 18
El cable RCA se conecta en polo a tierra al chasis del amplificador y el otro cable a los pines enumerados en el video. y se realiza puente con un cable del fusible al cable marron o cafe de la fuente de poder.....