![Doug Michael](/img/default-banner.jpg)
- 9
- 3 169
Doug Michael
Приєднався 6 вер 2012
Bauer Drill Press known flaw
1 minute video; 1 minute fix. The table support lock handle (as it came in the box) is installed backwards. Take it out; put it in the other end; it works. Good luck.
Переглядів: 21
Відео
Jura E8 Failure Point - frother quits working
Переглядів 2,4 тис.Рік тому
WARNING: Jura said opening the machine will VOID your warranty. OPEN AT YOUR OWN RISK. Jura E8 has a failure point inside the machine where an attached but unclamped hose pops loose. The frother quits working successfully at that point in time. We regularly clean our milk frother, but apparently not frequently enough to avoid this design issue. The hose in question has popped off twice in the l...
DIY Lunch - Spackle Salmon
Переглядів 806 років тому
Here's how you do it when the homeowners have packed up all utensils!
DIY Lunch - I have veggies... need salmon!
Переглядів 196 років тому
Homeowners left frozen salmon in frdge. Time to enjoy!
DIY Lunch - butter vegetables
Переглядів 596 років тому
Found veggies in fridge. Needed butter to sautee them. Part 1 of 3.
DIY Door knob installation with Felix and Dpa
Переглядів 626 років тому
Door knob fell off. Felix can help. (Sorry the video is inverted.)
DIY Ladder Safety with Finley and D-Pa
Переглядів 737 років тому
My blonde helper explains ladder safety
DIY Drywall Removal ; Sponsored by A-Positive
Переглядів 3677 років тому
Starbucks, Stanley, Girl Scout Cookies, Lowes, Menards, Home Depot, Target, Band-Aid, Frogtape, CVS, Walgreens, HyVee, Kobalt, Sharpie, Excedrin, Quickgrip
I sent them an intent to sue. I went back and forth for almost 2 years for when my warranty almost expired for the prick to make it seem like he’s doing me a favor. Then proceeds to tell me it’ll only have a 6 month extension to which I laughed and said- well, then I’ll send u another intent to sue
My Jura which was fixed 6 months ago is now leaking. We’ve found this issue
How to remove the side parts of the housing of Jura E8 EB? It's not as simple as you can see in the link you posted. I removed all the screws and the casing does not come off. Are there any latches? Could u make a short movie?
I agree with you, had the same problem with new Jura E8 EB. The hose fell off and water poured out of the coffee machine through the bottom of the housing. The new Jura was sent to the service center and the service said that the cause was too fine grinding of the coffee, which resulted in an increase in pressure in this hose. They did not put any clamp on it caiming they are not there to correct the Jura designers. They changed the grinder setting to the second stage, i.e. factory settings. Two months after returning from the service, the machine began to produce poor-quality foam with a lot of air bubbles and after rinsing the milk system it produces strange whistling sounds. Washing, rinsing or dismounting and cleaning foaming system does not help. I don't have the time to send a new coffee machine to the service center every two months because of the falling hose.
There is no reason to have clamp on that connection, there shouldn't be any pressure there. Look for blockage further down.
Way to go Felix!