- 21
- 40 463
Konner Coffey
Приєднався 18 вер 2013
Відео
a short, straight forward video on how to use a arc welding machine
Переглядів 164 роки тому
a short, straight forward video on how to use a arc welding machine
hydro ram disassemble
Переглядів 154 роки тому
this just a vidoe showing how the insides of a hydraulic ram operates
Pto functions
Переглядів 134 роки тому
this is a little explanation on a pto its history and how it functions
unsing manual ac machines
Переглядів 74 роки тому
This video is about using manual ac machine in recovering refrigerant, vacuuming the system, and charging the system back to standard
how to use an automatic ac machine
Переглядів 44 роки тому
this a quick video on how to use an automatic ac machine
cat c7 turbo measurements
Переглядів 3665 років тому
took measurements of the radial and axial play of the turbine of the turbo then the housing clearance of the fins too the housing it self
val adjustment on E7 Mack engine
Переглядів 40 тис.5 років тому
doing a valve adjustment on a e7 series mack ai 400 engine. extra notes: torque the jam nut to 45 ft lb, not the allen screw. for the valve. Steps: 1. Rotate engine clockwise facing the front engine to timing mark or to tdc of piston 1 or 6 2 Loosen all jam nuts and adjust the rods for either piston 1 or 6 depending on if the cylinder next to it has the intake valve being able to move. So you w...
code reader example with a maxisys
Переглядів 25 років тому
this is a coder reader test using the maxi sys code reader.
mounting and demounting a tire for a wheel on a coats wheel machine.
Переглядів 266 років тому
mounting and demounting a tire for a wheel on a coats wheel machine.
yeah i dont believe this is the Correct way.. you dont loosen them all up on TDC #1 my question is. when your on 1,6 on flywheel. i only have #1 intake loose and #6 exhaust lose. 1E and 6I are tight.
Is this the same for a MACK AI-375A ASET? Same procedure as this?
no wonder there are no comments good or bad............a terrible unplanned , not well thought out video.............if you didn't know how to do this adjustment after watching the video you still wouldn't know...........sorry, just my opinion
That pin is called a timing tab
Good, Coffey. Covered all the equipment. Now, something helpful is to explain a little more about the results we obtain after each tests. What means a 0.3V coolant reading. Using the hydrometer pouch table vs none balls floating, the purpose of the refractometer (show how to use it) and put the strip next to the bottle to see the difference. Keep practicing.
Good video. Showed important basic points about the multimeter. Including, testing the probing leads first, isolating the load for ohms reading, etc. Keep practicing with it.