Відео

It can be switched to GPM unit

@@marcosalamino9192 No. You only monitor the flow rate

First unplug the controller to turn off the power, then long press and hold SET, and then re-plug in the power again, the controller will restore to fac- tory settings after a "beep".

Pls send your questions to the email address: sale@digit-en.com

Hi please send your questions to out email: service@digit-en.com

You can set it for 2 seperate tanks or 1 tanks.

Yes, it can monitor it. but the rate depend on the flow sensor.

Pl send your questions to sale@digit-en.com.

www.amazon.com/dp/B00VKAT8A2?ref=myi_title_dp

Bipolar or polar

Yes, please send your request to email: sale@digit-en.com

Hello. You have misunderstood the way the thermostat works. Indeed any digital thermostat. In the situation you describe, with the temperatures you mention, the thermostat is in the phase of letting the room temp fall until it reaches the run temp of 68, at which time it will turn on the heater. The room temp will rise, and the thermostat will turn off when it reaches 78. Process repeats. 68-78f gives you a range of 20f, this is too large of a range for heating a space. You will get far better performance, consistent temps, with a range of 3 or 4f.

Hello, Please set the heater gear to max

Yes, it will work with heaters with thermostats. Just turn them up to full. It's not rocket surgery.

@@paulraymond1804 I believe you meant to say ( Rocket science )

@@davidpedder9048 no, I meant to say rocket surgery. It's a joke, a deliberate mixing of sayings.

No. we have the RPM meter for car.

Don't connect to temp sensor, or the temperature sensor is damaged

In heating mode, when the current temp is lower than RUN temp, the heating device will be on; in cooling mode, when the current temp is higher than RUN temp, the cooling device will be on.

@@digitenvictor1532 Yeah I know. The heater I had was too fancy with too many different electronic settings and controls. I had to plug in a more basic ceramic heater and it worked.

​​@DIGITEN Victor on mine, the current temp is 73 degrees. Run is set to 68, stop set to 78. 73 is within the run/stop set to heating. But the heater doesn't turn on unless the run temp is higher than the current temp. Meaning, I now have to adjust the run to 1 degree higher (74), in order for it to run. This is annoying bc you'd assume it should turn on at any temp between the run stop range. But it doesn't. This is also evidenced in this video without mention, why?

@@PanopticWebDesign If current temp is less than 68, the heater will on. First time, the current temp is higher than Run temp, so the heater will don't turn on, because the current meet the range you set. Or you can set RUN temp to 74, so the heater will on.Thanks.

Please send your question to customer service：service@digit-en.com

Magnet

NO, it is white sand, glued together by aquascape adhesive

7.5 Thanks

Thanks a lot.. I purchase smaller flow sensor YF- S401. It said 1/8"..., same question, what is the k-factor, please?

Please send your questions to the custom service.

Another product meet your requirement. ASIN:B08K31FCFC

Explaining what dv means and basic terms would help. Ie why do you need to set cooling if you already have temp set?

@@emsfromak75 I needed it for a mushroom growing set up but I don't need a heater the humidity is enougn to keep them warm

This meter power requirement is 12VDC, so yo can hook any 12VDC power supply to this.

Built-in the Remote

Change the alarm value to OF

@@digitenvictor1532 there’s no such option in SET though?

@@quidditistful Pls tell me your order id, may be yours is old version

@@digitenvictor1532 Ya I know that! But the method in the instructions does NOT work. The alarm will not go off. Can you please describe how to turn it off? And please don't quote the instructions , I have those. Or add detail to the instructions, because something is missing. Had it set up in 2 minutes, except that annoying alarm. I just got it today, so I assume it is a new model, from Amazon. Thank You

@@markpoidvin5382 Please send your order id to sale@digit-en.com

Yes, it is really great ATO

Please send your questions to email: service@digit-en.com.

www.amazon.com/DIGITEN-Temperature-Controller-Thermostat-Thermometer/dp/B07SJ75TFL/ref=sr_1_1_sspa?dchild=1&keywords=digiten+wtc200&qid=1623266041&sr=8-1-spons&psc=1&smid=A10ZX1GHP13ZSF&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEyRjFPRTFFTU04N1k5JmVuY3J5cHRlZElkPUEwMTczOTgxMVhLTTBXUVBHWTRLTiZlbmNyeXB0ZWRBZElkPUEwNzM1MTYzMUNMNVhNOTkzTUdWMyZ3aWRnZXROYW1lPXNwX2F0ZiZhY3Rpb249Y2xpY2tSZWRpcmVjdCZkb05vdExvZ0NsaWNrPXRydWU= About halfway down, below "product information", above "video's" is a "product guides and documents" where there is a PDF link.

Hold set and up arrow at the same time.