Відео

Thanks!

Only bearing I’ve found that last

This kits runs starts around 500 from gilomen but will go up depending on what add ons you get

Very possible. I am to the point now were you’re better off throwing the clutch away and replacing it with a new one . I use mother clutcher on almost all replacements . Polaris clutches are disposable in my opinion

Thanks! Depending on how far gone the clutch is depends how long it will last. I’ve seen a few clutches in excellent shape that only have sloppy rollers. I typically leave it up to the customer on what they want done , but most would rather install an aftermarket clutch vs paying labor cost on a rebuild. If the clutch shows wear in other places I would typically recommend a replacement clutch

Yes use a small bolt and a socket to press it out

Yes the ECU tune paired with the clutch kit is a big improvement on the Ranger and the General

@UTV GARAGE does it make your RPMs crazy high? stock they run like 6200 at 55mph etc. would you do it over again?

It comes with two primary springs. One will lower the rpm’s. I’m running the higher rpm spring in my crew cab and rpm’s are high but they level out one I get up to speed .

@UTV GARAGE so even with the higher RPM spring, it's not any worse than the stock once I get up to speed....I also have the crew cab. Just looking for a little more top end speed for when I take the family out joy riding etc. We have ours street legal. Kind of a do it all, farm work, trails and road.

No loctite