Відео

I guess this video would be interesting for a person with a stutter or some other ailment. Seriously wtf are you even talking about? Can I have the minutes back that I wasted watching this? If you don't have any knowledge to share keep your thoughts to yourself.

Remove tire from old rim. Use a torch and heat up the outside of rim along bearing. Run cool water inside rim to keep bearing cool. Use pipe diameter litter smaller than opening, place 2"x4" on top of pipe and hit wood with hammer the bearing will be easier to knock out. On new rim, drill holes for grease fitting

I got those too but when they are sitting outside most of the time 100% of the time the water get into them and rust them out from the inside because u cant get grease in there.

Question, where did you go to get the other bearings that are bigger sized? Your audio gets cut off when you mention it

Put out that joint, dude!

These wheels are junk, they will break, they arent welded on both sides.

i was actually able to knock the old bearings off the old tire/wheel...and they fit perfectly into the new wheel. new bearings knock out easy with socket extension & hammer. Your video helped me realize to do that so TYVM!

Had the exact same experience. Waiting on a 10 pack of bearings from Amazon for about 22 bucks. Didn’t want to spend 100 bucks or so on tires and tubes and put them on old hubs instead of spending around 30 for 2 harbor freight mounted 13 5.0 6 wheels and tires

Just get the plastic bushing ones for 2 reasons, a) When they wear they will NOT wear out the shaft they are on b) Many of those ball bearing ones you get they DON'T have grease in them and fail quickly & in the process of failure they can mess up the shaft

Keep your hand still!!

Thank you sooo much !

nice!

Way to go modern prepped! Don't forget to give us regular updates over the next several months. I'm sure your viewers would like to see your progress!