Відео

@@timothyjohn3006 thanks

@@Piupiu68az yes I thought about that, but they also go easier into the magazine. So I think there is something with the .249 slugs. Also looking at the colour difference...

@@AirgunNL And if they carry the cooler lubricant the 250 than the 249, hence the color difference?

@@Piupiu68az cooler lubricant?

The batch of 259 may be older than the 250, as they are lubricated, it may affect you.@@AirgunNL

@@bkmahaffey Last groep was +/- 970 fps. What I do is, I tune the speed mostly with the regulator. Sometimes the hammer spring needs one or two turns in,after the regulator pressure has been increased. I set the hammer spring so that it just opens the valve and then 2 turns extra in. This way the velocity is most consistent. After that I use the valve dwell time adjustment to make small adjustments. When you set the valve dwell time too high, you can hear a difference in the shot (Don't know how to explain, but it sounds like too much air is coming out). I didn't try to set the same speed yet with high reg and low dwell and vice versa. Maybe an interesting idea for a new video to check how much air is used in each shot with the different settings. I didn't set the regulator above 150 bar yet I think. Between 80 and 135 bar you can shoot 28 to 38 grain from 800-1050 fps.

Yes, newer models like P-3 have that.

@@markjohnson2166 no, standard.

@@JOLANGBUMBARA93 hello

@@SHOOTER3258 bought them. Will make a video this week.

ua-cam.com/video/9-_0Rptt9lY/v-deo.htmlsi=iWoEbh9XutGjeZDM

Cars are 370m away. It's not a fire arm... The bullet always goes down into the grass when I miss the target and wooden backstop. Even if I shoot 30 degrees up in the air the bullet isn't lethal at 370m.

Sure.

What weight?

@@AirgunNL 34g

@@kaosv1 I just ordered some 38 grain .250 and .248 H&N. Will make a video later this week.

See your other question

@@AirgunNL thanks for your answer 👍

Info on what? Mora, see other video's. PRS see comments on first Mora video.

www.airgunsofarizona.com/ will have them I think.

I think you can pre-order it at the moment.

I got it as test for the PRS Match in the Netherlands.

Ok but who give you this Mora ? RTI directly ?​@@AirgunNL

Cool, I WON’T buy it.

See your other question

Ik heb deze als test geweer voor de PRS match gehad.

Bedankt, ik had gehoopt dat hij al ergens beschikbaar was

No slugs is impossible. Even tried a FX liner. Doesn't work.

I have an LCS SK19 .22 and I am shooting casted slugs from MP -Molds (make them myself, huben version2 boat tailed and version 3 ringed solid cast). The version 3 at 38.7 gr are more accurate up to 150 m the version 2 at 35-37 gr fly further due to better bc. Best speeds at 870 - 920 f/s With the lcs, ammo consumption is a big issue ... so better cast them yourself

@@christosmavrommatis912 ok but how accurate. 1 moa at 100m? Longer versions might work. I believe shorter slugs wobble in the magazine when fired and hit the barrel edge. Therefore they are not accurate.

Send me some. I will try...😊

4.400 grams. With scope +/- 5.000. Quite heavy. So for hunting the compact might be better. For benchrest etc. the weight is only positive.

Not nervous just blocked nose so heavy mouth breathing. 😀

@@AirgunNL gargle with salt water, clean out nostrils, take antibacterial ointment and put a bit on a finger and swish it around each nostril and follow up with a spoon of honey and an vitamin E along with a vitamin C crushed up in the honey. it will make the antibiotic ointment absorbe in through the tissues there and also sterilize and then sooth the throat. because the throat nose and ears are all connected. might flush the ear on whichever side is more blocked also hot water and good soap in a bottle that can be squeezed and spray warm water into the ear but not under pressure just from an inch away. take care friend. TLW

Yes

@@AirgunNL for real?

@@derrickmitchell39dm www.rtiarms.shop/products/rti-mora-sniper

Ummmm, what?