Good video. I'd add two things: on mine the hex screw was covered by a rubber plug which needs to be removed before the hex nut can reached. It's about the size of a pencil eraser and can be pried out with a tiny screwdriver or something sharp. Keep it for reinsertion. Second, since the screw is not pre-threaded, as the video describes, I found it easier to start the screw BEFORE placing the cartridge in the faucet to make sure it goes in straight while you are not cramped for space. Nicely done!
i have same fuct Trask 19933-CZSD-DST installed in my kitchen. For ast couple of days handle keep falling off.not sure if this is cartirdge issue or just screw.
Good video. I'd add two things: on mine the hex screw was covered by a rubber plug which needs to be removed before the hex nut can reached. It's about the size of a pencil eraser and can be pried out with a tiny screwdriver or something sharp. Keep it for reinsertion. Second, since the screw is not pre-threaded, as the video describes, I found it easier to start the screw BEFORE placing the cartridge in the faucet to make sure it goes in straight while you are not cramped for space. Nicely done!
Thanks. Good tips
Helpful and straight to the point. Thanks.
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
Where does the O ring go?
i have same fuct Trask 19933-CZSD-DST installed in my kitchen. For ast couple of days handle keep falling off.not sure if this is cartirdge issue or just screw.
If handle keep falling off then your screw is loose. You need to tighten the hex screw with an Allen key
@@HowToDoitright already did,no success...still coming off.
@@tariqabbasi9277 yeah then call delta and they will send you a new valve. Replace it
Thanks so much. You really helped me!
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
finally found the vid that I'm looking for. thanks man!
I thought my cartridge might be defective because the screw hole wasn’t threaded. Good to know when screwing it in I create my own thread.
Maybe dumb question but do you need to turn off water to sink prior to changing out the part?
Yes definitely always turn off water
Is there any way to increase the flow on these
Nope. If flow is slow it might be your main water line.
do u have to turn water off before starting?
Oh yes definitely